Abstract:A new theoretical model was proposed to calculate the burst pressure of steel strip reinforced flexible composite pipes (steel strip PSP) based on the thin wall cylindrical shell theory and the squeeze pressure expression between layers was derived. The radial displacement discontinuity of pipe wall in pipe-end fitting joint area takes in account in this model which could result in Stress Concentration Effect (SCE) in reinforcement layers. The SCE is caused by swaging end fitting clamped tightly at the end of the pipe. The result of the hoop strain in the joint area calculated by this model is greater than the one calculated by the classic elastic model, which leads to relative conservative burst strength of the pipe. The hoop stress variation via internal pressure on innermost reinforcement layer is introduced to predict the burst strength of the pipe. As the stress in the joint area reaches its ultimate strength, the strain on the same layer in the point far away from this area (x?8) is extracted and the corresponding internal pressure is obtained as the burst strength of the pipe. The calculated data from two models were compared with the experiment results and the proposed new model showed better accuracy than the classic elastic model. Final additional parametric studies were conducted, while the effect of the pipe diameter, the winding angle, the number and thickness of the reinforcement layer on the burst strength of the pipe were studied. Useful conclusions were drawn for the design and application of the steel strip PSP in offshore engineering.

Optimal Winding Conditions of Flat Steel Ribbon Wound Pressure Vessels with Controllable Stresses

Analysis of Controllable Stress Distribution and Optimal Design of Flat Steel Ribbon Wound Pressure Vessel

CONTROLLABLE STRESS ANALYSIS AND DESIGN OF FLAT STEEL RIBBON WOUND PRESSURE VESSEL

Stresses Controllable Analysis and Optimal Design of Unique High Pressure Vessel Applied in Hydrogen Charge Station

Research on Reasonable Winding Angle of Ribbons of Flat Steel Ribbon Wound Pressure Vessel

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Mechanical Analysis of Carbon Fiber Wound High Pressure Hydrogen Storage Vessel and Prestress Control in Manufacturing Process

Optimal Control of Cylinder Wall's Stresses of Composite Material High-pressure Hydrogen Storage Vessel

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

SIMPLIFIED CALCULATION METHOD AND EXPERIMENTAL RESEARCH ON PRESTRESSED FOLDED-PLANE RETICULATED SHELL

Mechanical Analysis and Reasonable Design for Ti-Al Alloy Liner Wound with Carbon Fiber Resin Composite High Pressure Vessel

Mechanical Analysis and Optimal Control of Hydrogen Storage Vessels with Carbon Fiber Filament Wound Aluminum Liner

Design criteria for the unique flat steel ribbon wound pressure vessel

Experimental Investigation on the Deformation and Damage of Steel Ribbon Wound Vessel for Hydrogen Storage under External Impact and Blast Loading

New concepts on the interfacial friction behaviour between flat steel ribbon layers

Design Philosophy of Flat Ribbon Wound Layered Pressure Vessel

Heat-transfer Analysis of Flat Steel Ribbon-Wound Cryogenic High-Pressure Vessel

Modeling and Optimization of Ultra High Pressure Vessel with Self-Protective Flat Steel Ribbons Wound and Tooth-Locked Quick-Actuating End Closure

Theoretical Modeling Of Steel Strip Reinforced Flexible Pipe With Swaging End Fitting By Taking Into Account Stress Concentration Effect

Stress Analysis of Plastics Pipes Reinforced by Cross Helically Wound Steel Wires

Analysis on the rigid-plastic dynamic response of two-walled pressure vessels with flat-wound steel ribbons