Abstract:Aiming at the frequent issue of pit-shaped surface defects in S-bearing and Al-killed steel products and the related poor castability due to submerged entry nozzle (SEN) clogging, the melting and casting process of a popular auto steel Cf53 has been studied based on in-situ investigation and experimental analysis. To clarify the generation of the pit-shaped defects, the local surface chemistry, evolution of steel inclusions throughout the melting process, SEN clogging substances, and the internal relationship among them were systematically analyzed. The results show that this type of defect in the Cf53 rolled products is caused by the large-sized composite inclusions rich in CaS, which originate from the molten steel during the refining process, gradually accumulate on the inner wall of the SEN during casting, and finally lead to SEN clogging. The loose structure of clogging inclusions makes them prone to fall off into the mold and get trapped by solidifying steel shell. The formation mechanism of the inclusions was studied through FactSage software calculation. The results show that the increase in total sulfur and total calcium content, and the decrease in total oxygen content and temperature in steel will lead to CaS inclusion formation, which agrees reasonably well with experimental results. An optimized refining process to reduce calcium addition into molten steel is proposed accordingly, which achieves a remarkably alleviation in casting SEN clogging and an elimination of the pit-shaped defects on the final rolled products as well.

Defect Analysis and Quality Control on Stainless Steel Investment Casting

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Computer-Aided Engineering (CAE) Simulation for the Robust Gating System Design: Improved Process for Investment Casting Defects of 316L Stainless Steel Valve Housing

Study on Inclusions of Titanium-Stabilized Stainless Steel

Microstructural Analysis of Non-Metallic Inclusions in Atmosphere Melted and Poured Stainless Steel Investment Castings

Study on Casting Defect Control of Austenitic 304 Complex Structural Parts

Defects Analysis and Improvement for Electricmotorcar Aluminum Alloy Wheel by Gravity Casting

Analysis of Formation Mechanism of Typical Defects in Aluminum (Magnesium) Alloys Castings by the Expendable Pattern Shell Casting with Vacuum and Low Pressure

A review on prediction of casting defects in steel ingots: from macrosegregation to multi-defect model

Analysis and Improvement of Casting Defects from Pig Iron of Blest Furnace

Analysis of Casting Defects in Investment Casting by Simulation

Analysis of metallurgical defects in enamel steel castings

Study on Veining Defect of Investment Castings Produced by Colloidal Silica Shell Process

Fracture Analysis of Die-casting Mould for Water Pump

Cause analysis of nonconformity in ultrasonic flaw detection of 500 MPa high performance structural heavy steel plate

Advance in Research of Casting Defects of Directionally Solidified Nickel-based Single Superalloys

Formation mechanism and control of a kind of pit-shaped defect in Cf53 rolled products

Defect Analysis of Complex-Shape Aluminum Alloy Forging

Numerical and Experimental Study of the Elimination of Shrinkage in Complex and Small Investment Castings Using Water Cooling Process

Research on Casting Defects of 30Cr2Ni4MoV Heavy Steel Ingot