Abstract:Amorphous carbon (a-C), one of the most studied carbon-based films, has been widely applied in the filed of artificial joints due to its excellent mechanical and tribological properties and high corrosion resistance. However, low adhesive strength and poor fatigue resistance are fatal shortcomings of this kind of films. In this study, carbon (sp2-C:Ti/sp3-C:Ti) nano-multilayer films (MFs) with sequential sp3-rich and sp2-rich layers were deposited on Ti6Al4V and c-Si substrate by DC magnetron sputtering. X-ray diffraction, scanning electron microscopy, the X-ray photoelectron spectroscopy and the transmission electron microscopy were used to characterize the composition, structure and morphologies of the MFs. In the sp2-C:Ti/sp3-C:Ti MFs, the sp3-C rich layer and the sp2-C rich layer exhibit amorphous features and onion-like structure, respectively. Moreover, the layered structure is continuous in a relatively clear region but with a rough layer interface. The mechanical and the scratch behaviors were elaborately characterized by nanoindentation and scratch tests. The results revealed that the sp2-C:Ti/sp3-C:Ti MFs possess hardness of 21.9 GPa and excellent scratch behavior at sputtering bias voltage −220 V, which are significantly better than single-layer films. Furthermore, the adhesion and tribological behaviors of the sp2-C:Ti/sp3-C:Ti MFs were obtained by Rockwell and ball-on-disk tribometer tests. It was found that the sp2-C:Ti/sp3-C:Ti MFs synthesized under a sputtering bias of −220 V not only exhibit relatively low coefficient of friction (only 0.11) in humid air, but also present lower coefficient of friction (0.085) and wear rate (7.5 × 10−17m3N−1 m−1) of Si3N4 balls in Fetal bovine serum (FBS) solution. In conclusion, the critical loads and wear resistance of the sp2-C:Ti/sp3-C:Ti-MFs were effected by the sputtering bias and the mechanical properties of the MFs. And when sputtering bias is −220 V, the sp2-C:Ti/sp3-C:Ti MFs exhibited the improved mechanical properties, the lowest coefficient of friction (CoF) and the highest wear resistance.

Structure of Sp(2) Dominant A-C Film with Superhardness

Carbon Films with an Sp(2) Network Structure

Carbon films with a novel sp2 network structure

Microstructure and Electrical Properties of Amorphous Carbon Films Deposited Using Magnetron Sputtering

S P 3 -Rich Deposition Conditions and Growth Mechanism of Tetrahedral Amorphous Carbon Films Deposited Using Filtered Arc

Superlattice Structures Based on Amorphous Carbon

Comparative Study of the Tribology of Amorphous Carbon Films Via Magnetron Sputtering Depending on the Different Magnetic Field

Structure, mechanical properties and tribological behavior of sp2-C:Ti/sp3-C:Ti multilayer films deposited by magnetron sputtering

Structure and Tribology of Hard Carbon-Films Synthesized by Ion-Beam Deposition

Highly Tetrahedral Amorphous Carbon Films with Low Stress

Microstructure and Tribological Properties of Ti-contained Amorphous Carbon Film Deposited by DC Magnetron Sputtering

Surface Hardness Enhancement in Sp3-Bonded Carbon Doped SiC Nanocomposite Films

Structure and Giant Magnetoresistance of Carbon-Based Amorphous Films Prepared by Magnetron Sputtering

Molecular Dynamics Investigation of Metastable Structure and Hybridization Bond Evolution in High-Entropy CoCrFeNi Heterostructured Amorphous Carbon Films

Hard and crack resistant carbon supersaturated refractory nanostructured multicomponent coatings

Structural and mechanical properties of amorphous Si–C-based thin films deposited by pulsed magnetron sputtering under different sputtering powers

Structure and Mechanical Properties of A-C/(Alcrwtatinb)Cxny Composite Films

The Effect of Stress Relaxation on the Microstructure and Hardness Evolution of Pure Amorphous‐Carbon and C/Ti Multilayer Films

On the Structure of A New Superhard Hexagonal Carbon Phase

The Electrochemical and Mechanical Properties of Ti Incorporated Amorphous Carbon Films in Hanks' Solution

Enhancement of short/medium-range order and thermal conductivity in ultrahard sp3 amorphous carbon by C70 precursor