Abstract:A metallic part corrodes when it undergoes electrochemical reactions which cause the surface and structural deterioration of the metal. Through electroplating, metallic components can be protected from corrosion by coating them with Zn-Ni alloys. This study examined the electrodeposition of a Zn-Ni alloy film on a steel substrate from a chloride bath containing ethylene-diamine-tetraacetic acid (EDTA). A Pourbaix diagram using the OLI software was used to determine the stability of the Zn-Ni plating bath and the suppression of hydrogen evolution reaction (HER). Comparing the composition of Zn-Ni coating deposited in the EDTA bath with the pure Zn-Ni coating, the EDTA bath yielded higher deposition thickness and an average crystallite size reduction. The Zn-Ni coating deposited from the EDTA bath has a lower dissolution rate and better corrosion resistance properties than the non-EDTA bath. Polarization tests exhibited that the Zn-Ni alloy deposited from 0.119 mol/l EDTA bath at 20 mA/cm 2 current density showed lower corrosion current (Icorr) and more positive corrosion potential (Ecorr). Atomic force microscopy (AFM) and Vickers microhardness testing were used to characterize the morphological properties, topographic structures, and microhardness of Zn-Ni coatings.

Effect of nickel electroplating on the electrical properties of PMZNT relaxor ferroelectrics

Hydrogen-induced Degradation of PMN-based Relaxor Ferroelectrics During Nickel Electroplating

An Xps Study on the Degradation of Lead Magnesium Niobate-Based Relaxor Ferroelectrics During Nickel Electroplating

Investigation of electroplating-induced degradation of PMZNT relaxor ferroelectrics

Mechanism of resistance degradation of lead magnesium Niobate-based ferroelectrics induced by hydrogen reduction during electroplating

Resistance Degradation Of Lead Magnesium Niobate-Based Ceramics During Nickel Electroplating And Recovery Through Air Annealing

EFFECTS OF ULTRASONIC ELECTROLESS Ni- P PLATING ON THE CORROSION RESISTANCE OF SINTERED NdFeB MAGNETS

Reliability Improvement of PMZNT Relaxor Ferroelectrics Through Surface Modification by MnO2 Doping Against Electroplating-Induced Degradation

Functional Degradation of Nizncu-Based Multilayer Chip Inductors During Nickel Electroplating

Effect of annealing under N 2 atmosphere on electrical fatigue properties of PLZT ceramics

Effect of Sintering Conditions on the Reliability of PMN-Based MLCC Against Electroplating

Electroless Deposition of Ni-Co-P Deposit on NdFeB Permanent Magnets and Its Corrosion Resistance Property

Effects of Annealing on the Ageing Properties of Pmn-0.1pt Ceramics Doped by Transition-Metallic Ions

Influence of electroless nickel plating on multilayer ceramic capacitors and the implications for reliability in multilayer ceramic capacitors

Study on Dielectric-Properties of Pmn-Pzn-Pt Ferroelectric Relaxor Ceramics

Effect of electroless deposition on the corrosion resistance property for NdFeB permanent magnets with surface coating of Ni-P alloy

The effect of excessive content of Ni and annealing on 0.70Pb(Ni1/3Nb2/3)O-3-0.30PbTiO(3) relaxor ferroelectric ceramics

The effect of excessive content of Ni and annealing on 0.70Pb(Ni 1/3Nb2/3)O3-0.30PbTiO3 relaxor ferroelectric ceramics

A New Mechanism for the Influence of Electroplating and Electroless Plating on Ferroelectric Components

The Performance of Zn-Ni Alloy Coating Electrodeposited from Stabilized Bath

Effects of Silver Incorporation on the Dielectric and Ferroelectric Properties of PMN–PNN–PZT Ceramics