Abstract:A new approach to reduce the cycling capacity degradation of Mg–Ni-based alloy through lowering the polarization resistance by means of element substitution is suggested in this study. A new Mg-based amorphous alloy Mg45Fe5Ni50 was prepared by means of mechanical alloying. The cycling stability of this alloy which is found superior to that of Mg50Ni50 and several other A side-substituted Mg-based ternary alloys. A comparative study on the surface layer formed on Mg50Ni50 and Mg45Fe5Ni50 during cycles was made by the X-ray photoelectron spectroscopy (XPS) and electrochemical impedance spectroscopy (EIS). XPS analysis demonstrates that, the degree of oxidation of the two alloys are almost the same. Mg on the surface of both alloys transforms into Mg(OH)2 passive film and the Mg (2P) binding energy peaks of both alloys before and after different cycles are also similar. The only cause for the difference in cycling stability of the two alloys is the difference in polarization resistance RP, which leads to different potential drops in the charge/discharge processes. On the basis of the EIS Nyquist diagrams and corresponding equivalent, the RP values of different cycles of both alloys were calculated through non-linear least-squares fitting. For Mg45Fe5Ni50, the polarization resistance is lower. The metallic Fe was believed to be beneficial for suppressing the polarization resistance RP and elevating the cycling discharge plateau, thus improving the cycling discharge-ability. This phenomenon may be useful in preparing more durable Mg–Ni-based electrode alloys.

Mechanism of resistance degradation of lead magnesium Niobate-based ferroelectrics induced by hydrogen reduction during electroplating

An Xps Study on the Degradation of Lead Magnesium Niobate-Based Relaxor Ferroelectrics During Nickel Electroplating

Hydrogen-induced Degradation of PMN-based Relaxor Ferroelectrics During Nickel Electroplating

Resistance Degradation Of Lead Magnesium Niobate-Based Ceramics During Nickel Electroplating And Recovery Through Air Annealing

Investigation of electroplating-induced degradation of PMZNT relaxor ferroelectrics

Effect of nickel electroplating on the electrical properties of PMZNT relaxor ferroelectrics

EFFECTS OF ULTRASONIC ELECTROLESS Ni- P PLATING ON THE CORROSION RESISTANCE OF SINTERED NdFeB MAGNETS

Reliability Improvement of PMZNT Relaxor Ferroelectrics Through Surface Modification by MnO2 Doping Against Electroplating-Induced Degradation

Effect of Sintering Conditions on the Reliability of PMN-Based MLCC Against Electroplating

Functional Degradation of Nizncu-Based Multilayer Chip Inductors During Nickel Electroplating

Hydrogen-Induced Lateral Growth of Nickel Coating on Ba3co2fe24o41(Co(2)Z)-Based Hexaferrite During the Electroplating of Multilayer Chip Inductors

Electroless Deposition of Ni-Co-P Deposit on NdFeB Permanent Magnets and Its Corrosion Resistance Property

A New Mechanism for the Influence of Electroplating and Electroless Plating on Ferroelectric Components

Reconditioning of Electroless Nickel Plating Bath on Magnesium Alloys

Effect of electroless deposition on the corrosion resistance property for NdFeB permanent magnets with surface coating of Ni-P alloy

Hydrogen-Induced Degradation and Aging of Pb(Mg1/3Nb2/3)O3-Based X7R Multilayer Ceramic Capacitors

The Reduction of Cycling Capacity Degradation of Mg–Ni-based Electrode Alloys by Fe Substitution

Influence of electroless nickel plating on multilayer ceramic capacitors and the implications for reliability in multilayer ceramic capacitors

Effects of Electrochemical Hydrogen Charging on Lead-Based Relaxor Ferroelectric Multilayer Ceramic Capacitors

Environmentally friendly and facile Mg(OH) 2 film for electroless nickel plating on magnesium alloy for enhanced galvanic corrosion inhibition

Degradation Mechanism Of The La-Mg-Ni-Based Metal Hydride Electrode La0.7mg0.3ni3.4mn0.1