Abstract:This paper establishes a transient equivalent circuit of cross‐line same‐phase successive grounding faults, and analyses the characteristics of zero‐sequence current. Then, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed. Finally, a method for faulty line detection based on cross‐correlation distance and transient energy is proposed and different fault conditions verify the effectiveness of proposed method. Currently, theoretical analysis of single‐phase grounding (SPG) faults in low‐current grounding systems has reached a high level of refinement, and the corresponding detection methods have matured. However, there is a significant lack of research on successive grounding (SG) faults, particularly in the area of detecting cross‐line same‐phase successive grounding (CSSG) faults in arc suppression coil grounding systems. To address these issues, a novel faulty line detection method based on transient characteristics of CSSG is proposed. Firstly, a transient equivalent circuit is established, and the characteristics of transient zero‐sequence current (ZSC) are theoretically analysed. Secondly, variational mode decomposition (VMD) is employed to extract low and high‐frequency information from intrinsic mode functions (IMFs). Subsequently, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed, which can accurately detect the occurrence time of secondary faults. Finally, a method for faulty line detection based on cross‐correlation distance (CCD) and transient energy (TE) is proposed. The results of PSCAD simulation under different conditions and field test affirm the accuracy of the analysis and the effectiveness of the proposed method.

Exploration of the FPS Fault Location System

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Typical Fault Cause Recognition of Single-Phase-to-Ground Fault for Overhead Lines in Nonsolidly Earthed Distribution Networks

Fast Fault Protection Based on Direction of Fault Current for the High-Surety Power Supply System

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Single Line-to-ground Fault Location and Information Modeling Based on the Interaction between Intelligent Distribution Equipment

A novel fault locator for power distribution system with neutral non-effectively grounded

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Faulty Section Location Method Based on Dynamic Time Warping Distance in a Resonant Grounding System

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

A Fault Section Location Method for Small Current Neutral Grounding System Based on Energy Relative Entropy of Generalized S-Transform

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Research on a New Single-End Fault Location Method for Single-Phase Grounding Faults of Transmission Lines Through Transition Resistance

An FTU-Based Method for Locating Single-Phase High-Impedance Faults Using Transient Zero-Sequence Admittance in Resonant Grounding Systems

Power Distribution Network Ground Fault Location Algorithm Using On-Line Detectors

The Impact of Cross Line Different-Phase Successive Faults on Fault Detection Devices

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics