Abstract:Multi-channel wire electrical discharge machining (WEDM) is widely used for slicing semiconductor materials and improving cutting rate through multi-channel discharge. However, enhancing the cutting rate of integral metal workpieces through the utilization of multi-channel WEDM remains a challenge. This paper investigated the discharge characteristics of metal workpiece using multi-channel high-speed WEDM (HSWEDM). It was discovered that due to the high conductivity of the metal workpiece, there is electrical signal coupling between each channel, which inhibits the independent discharge of each channel and severely impacts the improvement of cutting rate. To solve this problem, a new power supply with a decoupled circuit was designed, and the potential difference between adjacent channels was formed by using a current-limited resistor at each output, reducing coupling between the channels and enabling independent discharges at each channel, thereby improving the cutting rate of metal materials. The effect of current-limited resistance ( R c ) on multi-channel synchronous discharges was analyzed through online acquisition of discharge signals, demonstrating that reducing the R c can improve the discharge ratio. In the two-channel HSWEDM with the new power supply, when the R c is reduced from 15 to 5/3 Ω, the gap voltage is increased from 31 to 64 V, the discharge ratio is increased from 0.967 to 1.566, and the increase in cutting rate was from 19.06% to 83.02%. Furthermore, when R c is 5/2 Ω, the cutting rate was 1.660–1.971 times that of conventional power supply. Since each channel can implement independent servo control after electrical signal decoupling, the dimensional uniformity and surface topography of grooves are improved, and the thickness of the recast layer is reduced. Lastly, the new power supply was applied to the four-channel HSWEDM, resulting in a significant increase in cutting rate, which was 3.538 times higher than that of conventional power supply.

Experimental study of MWEDM technology

Machining of Micro-electrode Array by WEDM

A study on wire electrochemical micromachining for fabrication of microgrooves

Gap status identification and control of wire electrochemical micromachining

Study on the Preparation Process for High Accuracy Micro Machining by Wire Electrical Discharge Machining

Improvement of the Machining Characteristics in WEDM Based on Specific Discharge Energy and Magnetic Field–assisted Method

Research on the Key Technologies of Micro Electro Discharge Machining

Analysis and Reduction of Process Energy Consumption and Thermal Deformation in a Micro-Structure Wire Electrode Electric Discharge Machining Thin-Wall Component

Experimental study on the influence of workpiece shape on discharge gap and burr in LS-WEDM and the preparation of microelectrode array with specific size

Influence of Discharge Current on Machined Surfaces by Thermo-Analysis in Finish Cut of WEDM

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Investigation on a Novel Surface Microstructure Wire Electrode for Improving Machining Efficiency and Surface Quality in WEDM

Theoretical and Experimental Investigation into Machining Characteristics of VHF Micro-EDM

An overview to micro-wire-electrical discharge machining

Experimental investigation of wire electrical discharge machining parameters on WE43 magnesium alloy

Wire Electrochemical Machining with Pulsating Radial Electrolyte Supply and Preparation of Its Tube Electrode with Micro-Holes

Plasma characteristics and material erosion mechanism in multi-channel wire electrical discharge machining

Influence of Machining Parameters on Surface Roughness in Finish Cut of WEDM

Study on surface evenness of super-high-thickness cutting in high-speed wire electrical discharge machining

Study on discharge characteristics and process of multi-channel high-speed wire electrical discharge machining for metal workpieces

Evaluation of Wire Electrical Discharge Machining Performance Features on EN AW-6082 T6 Aluminum Alloy and Optimization of Machining Characteristics