Abstract:In wire electrical discharge machining (WEDM), increasing the machining characteristics is always a research hot spot. Now, magnetic-assisted method cannot directly improve the performance of WEDM during machining magnetic material. In addition, due to the defects of convergence precision, convergence speed, global optimization, and subjectivity, the application of individual parameter optimization algorithm is limited. In order to address these problems, this paper proposes magnetic-assisted method and modified non-dominated neighbor immune algorithm to ameliorate the performance of WEDM in trim cutting magnetic material. Firstly, the force analysis of debris and the analysis of discharge current waveform are carried out to clarify what setting condition of the magnetic field generator is proper. It is indicated that the magnetic-assisted method maybe improves the machining characteristics of WEDM when the Lorentz force has the same direction with dielectric flashing force during trim cutting magnetic material. Additionally, a set of trim cutting Taguchi experiment is accomplished to investigate the effect of magnetic-assisted method on material remove rate (MRR), surface roughness (SR), and recast layer thickness (RLT). Thereinto, it can be found that the machining characteristics of WEDM are obviously improved by magnetic-assisted method. More specifically, under magnetic-assisted method, MRR, SR, and RLT are improved by an average of 18.45, 17.86, and 17%, respectively. Then, on the basis of game theory, the modified non-dominated neighbor immune algorithm (NNIA) is proposed to select best process parameters for further increasing the machining characteristics of magnetic-assisted WEDM (MA-WEDM). Eventually, the comparative results of three algorithms and verification experiment demonstrate that this modified NNIA exhibits better optimization performance than NSGA-II and NNIA. Specifically, by modified NNIA, the largest increase of MRR and the greatest decrease of SR and RLT are 22.37, 44.59, and 15.07%, respectively.

Improvement of the Machining Characteristics in WEDM Based on Specific Discharge Energy and Magnetic Field–assisted Method

Theoretical and Experimental Study of Magnetic-Assisted Finish Cutting Ferromagnetic Material in WEDM

Investigation on a Novel Surface Microstructure Wire Electrode for Improving Machining Efficiency and Surface Quality in WEDM

Influence of Machining Parameters on Surface Roughness in Finish Cut of WEDM

Magnetic-assisted Method and Multi-Objective Optimization for Improving the Machining Characteristics of WEDM in Trim Cutting Magnetic Material

Influence of Discharge Current on Machined Surfaces by Thermo-Analysis in Finish Cut of WEDM

Determination of the Optimal Servo Feed Speed by Thermal Model During Multi-Pulse Discharge Process of WEDM

Analysis and Reduction of Process Energy Consumption and Thermal Deformation in a Micro-Structure Wire Electrode Electric Discharge Machining Thin-Wall Component

Study on removal of recast layer of NiTi shape memory alloy machined with magnetic field-assisted WEDM-ECM complex process

Study on discharge characteristics and process of multi-channel high-speed wire electrical discharge machining for metal workpieces

Researches on the EDM of magnetized sintered NdFeB permanent magnetic material

Sustainable Production of High-Uniformity Workpiece Surface Quality in Wire Electrical Discharge Machining by Fabricating Surface Microstructure on Wire Electrode

Experimental Study and Parameter Optimization on Sustainable and Efficient Machining GH4169 with Rotating Short Arc Milling Method

A New Wire Electrode for Improving the Machining Characteristics of High-Volume Fraction SiCp/Al Composite in WEDM

Magnetic field–assisted ultrasonic EDM removal mechanism and surface morphology study

Optimization of Process Parameters on Surface Integrity in Wire Electrical Discharge Machining of Tungsten Tool YG15

A comparative investigation on magnetic field–assisted EDM of magnetic and non-magnetic materials

A review on magnetic field assisted electrical discharge machining

High-speed Near Dry Electrical Discharge Machining

Evaluation of Wire Electrical Discharge Machining Performance Features on EN AW-6082 T6 Aluminum Alloy and Optimization of Machining Characteristics

Experimental investigation on the surface quality of WEDM machined 20MnCr5 steel for Gear application