Abstract:The crystal structural quality and the strain induced by the substrate strictly impose the magnetic and transport properties of La0.67Sr0.33MnO3 (LSMO) films. In particular, the magnetic anisotropy (MA) of epitaxial LSMO can be finely tuned by varying its thickness and by choosing single crystal substrates with a suitable lattice mismatch with the film. Here, we have deposited LSMO films with thicknesses in the 12–50 nm range by pulsed laser deposition on different single crystal substrates inducing either compressive or tensile in-plane strain on the manganites. The epitaxial quality of films was quantified by ω-scans around a (002) peak with full-width half-maximum values as low as 0.08° for films on the nearly matched NGO (110) substrate to 1.4° films on the high mismatched MgO (001) substrate. As the epitaxial strain in a thin-film increases, a significant reduction in the metal-insulation transition temperature (Tp) was observed. The magnetic properties of the films probed by Kerr magnetometry show that the symmetry of the room temperature MA varies significantly as a function of both strain and thickness. Specifically, we observed pure uniaxial MA on NGO (110) and pure biaxial MA on STO buffered MgO (001), whereas a spin reorientation from uniaxial in-plane to out-of-plane on LSAT (001) and uniaxial to nearly isotropic in-plane on STO (001) substrate as the film thickness is increased. We provide an efficient tool to tune the MA according to the specific spintronic application targeted.

The Epitaxial Growth of the Lacamno Thin Films with the Cmr Effects Prepared by A New Method: Precursor Film Sintering

Structural and Magnetoresistive Property of the LaCaMnO Thin Films Prepared by a New Method: Precursor Film Sintering

Preparation and Structure of La_(0.5)Ca_(0.5)Mn_xTi_(1-x)O_3 Thin Film Deposited by Magneto Controlled Sputtering

Preparation of Submicron LaCaMnO Submicron Powder and LaCaMnO–alumina Composites with CMR Effects by a New Method: Precursor Sintering Technique

Growth, structural characteristics and magnetoresistance in La-Ca-Mn-O thin films prepared by dc magnetron sputtering

Epitaxial Growth of LaMnO3 Buffer Layer by Magnetron Sputtering Method

Substrate and Thickness Effects on Structure and Transport Properties of La2/3ca1/3mno3 Films

EPITAXIAL GROWTH OF La 0.5 Sr 0.5 CoO 3 THIN FILMS AND ITS MECHANISMS

Preparation and characterization of epitaxial La0.65Sr0.35MnOz thin films grown by pulse laser deposition

Preparation and structure of La0.5Ca0.5Mnx Ti1-xO3 thin film deposited by magneto controlled sputtering

Epitaxial growth and properties of La0.7Sr0.3MnO3 thin films with micrometer wide atomic terraces

Epitaxial strain and thickness dependent structural, electrical and magnetic properties of La0.67Sr0.33MnO3 films

Epitaxial Growth and Characterization of RF-Sputtered LaMnO 3 Cap Layers on Homo-Epi MgO/IBAD–MgO Templates

Epitaxial Growth and Magnetic/transport Properties of La0.7Sr0.3MnO3 Thin Films Grown on SrTiO3 with Optimized Growth Conditions

Structural study and magnetoresistance effect of epitaxial La0.67Sr0.33MnO3–δ and Pr0.7Ca0.3MnO3−δ multilayer films

The synthesis and magnetoresistance behavior of direct current magnetron sputtering thin film of La0.7Pb0.3MnO3-δ

Enhancing The Orthorhombicity And Antiferromagnetic-Insulating State In Epitaxial La0.67ca0.33mno3/Ndgao3(001) Films By Inserting A Smfeo3 Buffer Layer

Influence of Epitaxial Growth on Phase Competition in Pr0.5sr0.5mno3 Films

Nano-Ordered Palpus-Like Crystals In La(1/3)Ca(2/3)Mno(3) Films

Annealing Induced Coherent Evolutions of Biaxial Strain and Antiferromagnetic-Insulator Phase in La0.625Ca0.375MnO3 Films

Preparation of La0.7Sr0.3Mn1+xOy (1 ⩽ X ⩽ 4) Thin Films by Chemical Solution Deposition: Dual Epitaxy and Possible Spinodal Growth