Abstract:Aiming at enhancing the electrochemical characteristic of RE-Mg-based composite, the partial substituting La with Ce experiment in the composites was conducted, and the surface modification treatment of the alloys was performed by mechanical coating Ni. By means of mechanical trituration, The La 10-x Ce x Mg 80 Ni 5 (x = 0–2) + y wt% Ni (y = 50–200) compound materials which have the structures of nanocrystalline and amorphous were synthesized. In order to make sense of the principle action of Ce and Ni elements in structural and electrochemical properties of the material, some deep research were carried out. According to the final results, the as-milled composites have the electrochemical hydrogen absorption and hydrogen desorption abilities at room temperature. Having no use for activation, the as-milled composites can reach the maximum discharge capacities when the first cycling was carried out. With the Ni value x changed from 50 to 200, the discharge capacity was varied from 70.5 mAh/g to 902.1 mAh/g; moreover, the capacity retention rate at 20th cycle (S 20 ) and high rate dischargeability (HRD) of the (x = 0) composite were heightened from 67.2 % to 82.3 %, from 50.6 % to 55.7 % respectively. The composites' (y = 100) discharge capacity has a maximum value 118.5 mAh/g when the Ce value x is 1. The capacity retention rate (S 20 ) is enhanced from 53.3 % to 68.5 % by lifting Ce content from x = 0 to x = 2. what's more, the high-rate discharge ability (HRD), the electrochemical impedance spectrum (EIS), potentiodynamic polarization curves, and potential-step measurements all intimate that substituting La with Ce clearly promotes the composites' electrochemical kinetic properties, but maximum values emerge only when the x value is 1.

Corrosion Behaviour of AM60 Magnesium Alloys Containing Ce or La under Thin Electrolyte Layers. Part 2: Corrosion Product and Characterization

Corrosion Behaviour of AM60 Magnesium Alloys Containing Ce or La under Thin Electrolyte Layers. Part 1: Microstructural Characterization and Electrochemical Behaviour

Effect of Rare Earth Element Ce and La on Corrosion Behavior of AM60 Magnesium Alloy

Magnesium Alloy Corrosion under Thin Electrolyte Layer Using Electrochemical Impedance Spectroscopy and Polarization Curve

Influence of mixed rare earth elements(Y and Ce) on the microstructure and corrosion behaviour of Mg-4Al-3Ca alloy

EFFECT OF CERIUM AND LANTHANUM ALLOYING ON MICROSTRUCTURE AND CORROSION BEHAVIOR OF AZ91 MAGNESIUM ALLOY

Microstructures, Mechanical Properties and Corrosion Resistances of Extruded Mg-Zn-Ca-Xce/La Alloys

Investigation of Az91d Magnesium Alloy Corrosion Behavior under Thin Electrolyte Layer Using Nondestructive Electrochemical Techniques

Effect of Ce replacing La on the electrochemical performance of amorphous grain boundaries Mg-Ni-based materials

Corrosion resistance of anodically oxidized LY12 aluminum alloy after modification with cerium nitrate and silane

On the corrosion of binary magnesium-rare earth alloys

Corrosion Behavior of Pure Zinc and Its Alloy under Thin Electrolyte Layer

Exfoliation Corrosion of As-Extruded Mg–1Li–1Ca: the Influence of the Superficial Layer

Tailoring the microstructure and enhancing the corrosion resistance of extruded dilute Mg-0.6Al-0.5Mn-0.25Ca alloy by adding trace Ce

Electrochemical Behavior of ZE41 Magnesium Alloy under Simulated Atmospheric Corrosion

A Comparison Study of Ce/La and Ca Microalloying on the Bio-Corrosion Behaviors of Extruded Mg-Zn Alloys

Effect of adding Y and Ce on corrosion behaviour of the extruded ZK60 magnesium alloy

Effect of Chloride Ion Concentration on Electrochemical Behavior and Corrosion Product of Am60 Magnesium Alloy in Aqueous Solutions

Effect of Rare Earth Elements (Y, La) on Microstructural Characterization and Corrosion Behavior of Ternary Mg-Y-La Alloys

Microstructural homogeneity, texture and corrosion properties of RE-doped 55Mg-35Pb-9.2Al-0.8B alloy fabricated via equal channel angular pressing (ECAP)

Localized Corrosion of Magnesium Alloys in NaCl Solutions Explored by Scanning Electrochemical Microscopy in Feedback Mode