Abstract:The transformation-assisted consolidation under pressure has been demonstrated to be a promising method to fabricate the nano or submicron polycrystalline ceramic materials. The high pressure suppresses the long-range diffusion of the atoms and, consequently, restrains the grain coarsening. The new phases produced at high pressure could show finer grains under the appropriate thermodynamic conditions, which are not subject to the grain size of the raw materials. Ceramic materials exhibit the existence of the transformations under certain thermodynamic conditions and the formation of new phases generally undergoes the nucleation and growth. In the present work, monoclinic microcrystal ZrO2 with average grain size of 2 µm and Y2O3 with average grain size of 50 nm were mixed in molar ratio of 97∶3. The preparation of the samples was carried out by sintering at 5.5 GPa and temperatures of 800–1700 °C using the high pressure cubic cell, and the sample characterization was performed via the X-ray diffraction, scanning electron microscope and transmission electron microscopy. It was found that the monoclinic and submicron tetragonal composite polycrystalline ZrO2 in bulk is obtained under high pressure and high temperature. The average grain size of tetragonal ZrO2 fabricated at 1200, 1400, 1600 and 1700 °C is (145±62) nm, (246±165) nm, (183±62) nm and (245±107) nm, respectively. The synthesis of the fine-grained polycrystalline materials by the transformation under high pressure can solve the problems of agglomeration, adsorption and grain coarsening caused by the nanopowders as the starting materials in the conventional approach, which would be an alternative route to fabricate the fine-grained polycrystalline materials with the enhanced performances.

Effect of Maltose for the Crystallization of Tetragonal Zirconia

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Controlled sintering and phase transformation of yttria-doped tetragonal zirconia polycrystal material

Unusual Calcination Temperature Dependent Tetragonal–monoclinic Transitions in Rare Earth-Doped Zirconia Nanocrystals

Controlling Crystal Transformation Between Zeolite Zsm-5 and Mordenite Without Organic Structure-Directing Agent

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Atomic force microscopy study of the tetragonal to monoclinic transformation behaviour of silica doped yttria-stabilized zirconia

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Tetragonal‐to‐Monoclinic Phase Transitions in Nanocrystalline Rare‐Earth‐Stabilized Zirconia Prepared by a Mild Hydrothermal Method

Preparation and Microstructure of Nanometer Tetragonal Polycrystal Zirconia Powder at Low Temperature Condition

Microstructure and phase transformation behavior of Al2O3–ZrO2 under microwave sintering

Effects of Synthetic Parameters in Pechini Method on the Formation and Properties of (zro2)0.92(sc2o3)0.08 Solid Solution

High Pressure Synthesis versus Calcination – Different Approaches to Crystallization of Zirconium Dioxide

The Effect of Al2O3 on the Thermal Stability and Mechanical Properties of 3Y-TZP

Monoclinic to tetragonal transformations in hafnia and zirconia: A combined calorimetric and density functional study

Tetragonal reconstruction and monoclinic variants rearrangement during heat treatment in zirconia

Crystallization of t-ZrO2 in zirconia powder prepared by sol-gel process

Optimization of the structure and morphology of monoclinic phase nanoscale zirconium dioxide

Effect of Si/Zr molar ratio on the sintering and crystallization behavior of zircon ceramics

Crystallization, structure, and properties of TiO2-ZrO2 co-doped MgO-B2O3-Al2O3-SiO2 glass-ceramics