Abstract:Ellipsoidal and torispherical heads, whose geometric shapes are close, are usually used as end closures of internally pressurized vessels. In pressure vessel codes, for example, ASME BPVC Section VIII, ellipsoidal heads are designed as torispherical heads using geometric equivalency approaches. However, the difference between ellipsoidal and equivalent torispherical heads has not been studied in detail. In this paper, we first investigate the shape deviation between the two types of heads. Then we compare the elasticplastic behaviors between ellipsoidal and equivalent torispherical heads as well as their failure modes, i.e., buckling and plastic collapse. It is found that ellipsoidal heads have more buckling resistance than equivalent torispherical heads, indicating that the current design rules for buckling failure based on the geometric equivalency approaches result in uneconomical design. Nevertheless, the shape deviation has little effect on plastic collapse pressures of ellipsoidal and equivalent torispherical heads, showing that the geometric equivalency approaches are applicablefor such heads thatfail by plastic collapse (bursting). In addition, the experimental and numerical results show that such heads experience geometric strengthening. The FE method considering the effect of geometric strengthening provides a good prediction about plastic collapse (bursting) pressure. However, the current design equation for bursting does not consider the effect ofgeometric strengthening, also leading to uneconomical design. Therefore, in order to avoid uneconomical design, we recommend that (1) with respect to the buckling of ellipsoidal heads, a new design equation be proposed rather than implementing the geometric equivalency approaches, and (2) the current design equation for bursting be deleted, and a new design equation, considering the effect of geometric strengthening, be proposed for the bursting of ellipsoidal and torispherical heads subjected to internal pressure.

Plastic Buckling of Internal Pressurized Torispherical Pressure Vessel

Analysis of the Elastic-Plastic Buckling Behavior of the Pressure Vessels with Dished Heads under Internal Pressure

Buckling behaviour of imperfect ring-stiffened cone–cylinder intersections under internal pressure

The Influence of Initial Geometric Imperfection on the Localized Buckling of Pressure Vessel under Internal Pressure

Buckle Propagation of Sandwich Pipes under External Pressure

Localized Nonlinear Buckling of Pressure Vessel under Internal Pressure Caused by Initial Geometric Imperfections

COMPARISON OF ELLIPSOIDAL AND EQUIVALENT TORISPHERICAL HEADS UNDER INTERNAL PRESSURE: BUCKLING, PLASTIC COLLAPSE AND DESIGN RULES

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Analytical Study on the Buckling of Cylindrical Shells with Stepwise Variable Thickness Subjected to Uniform External Pressure

Buckling performance of inner corrugated pressure shells under external hydrostatic pressure

BUCKLING OF 3D BRAIDED COMPOSITE CYLINDRICAL SHELLS UNDER EXTERNAL PRESSURES

Finite Element Analysis of Tangential Rectangle Joint Pipe on the Shell of an Cyclone

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Buckling of Cylindrical Shells with Arbitrary Circumferential Thickness Variations under External Pressure

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Buckling Strength of Tapered Cylindrical Shells under Partial Axial Compression: Effect of Circumferential Weld-Induced Imperfections

Buckling collapse of submarine thick-wall pipe under torque and hydraulic pressure based on vector form intrinsic finite element method

New formula for predicting the plastic buckling pressure of steel torispherical heads under internal pressure