Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Regrowth of Zno Thin Film with High Surface Flatness and Enhanced Optical Properties on Annealed Buffer Layers by Rf Sputtering Deposition

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

Sputtering Growth of Preferential C-Axis-oriented Aluminum Nitride Film Using Homogeneous Buffer Layer

Epitaxial Growth Of Zno On Gan/Sapphire Substrate By Radio-Frequency Magnetron Sputtering

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

The Growth and Annealing of Single Crystalline Zno Films by Low-Pressure Mocvd

Effect of Growth and Annealing on ZnO Buffer by MOCVD

In Situ and Ex Situ Investigation on the Annealing Performance of the Zno Film Grown by Ion Beam Deposition

Study on the annealed ZnO films grown by plasma-assisted MOCVD

Crystal growth, finite element analysis and oxygen annealing of ZnO bulk crystal grown by low-temperature-gradient chemical vapor transport

Crystal Growth of Undoped ZnO Films on Si Substrates under Different Sputtering Conditions

Growth of high-quality ZnO thin films on (11\bar{2}0) a-plane sapphire substrates by plasma-assisted molecular beam epitaxy

Effect of Post-Thermal Annealing on Properties of Zno Thin Film Grown on C-Al(2)O(3)By Metal-Organic Chemical Vapor Deposition

MICROSTRUCTURE AND PROPERTIES OF ANNEALED ZnO THIN FILMS DEPOSITED BY MAGNETRON SPUTTERING

Molecular Beam Epitaxy Growth of Single-Domain and High-Quality ZnO Layers on Nitrided (0001) Sapphire Surface

Annealing Effect on Properties of Zno Thin Films Grown on LiNbO3 Substrates by MOCVD

Initial growth behavior and resulting microstructural properties of heteroepitaxial ZnO thin films on sapphire (0001) substrates

Tri-Buffer Process: A New Approach to Obtain High-Quality Zno Epitaxial Films on Sapphire Substrates

B23-O-15 Van Der Waals Epitaxial Growth of Highly-textured ZnO Thin Film on Surface-modified Silicon Substrates by Chemical Bath Deposition

Growth of High-Quality ZnO Thin Films on ( 112̅0 ) A-Plane Sapphire Substrates by Plasma-Assisted Molecular Beam Epitaxy

Forming Extremely Smooth Zno Thin Film on Silicon Substrates for Growth of Large and Well-Aligned Zno Rods with the Hydrothermal Method