Abstract:High-quality ZnO films were grown on Si(1 0 0) substrates with low-temperature (LT) ZnO buffer layers by an electron cyclotron resonance (ECR)-assisted molecular-beam epitaxy (MBE). In order to investigate the optimized buffer layer temperature, ZnO buffer layers of about 1.1 μm were grown at different growth temperatures of 350, 450 and 550 °C, followed by identical high-temperature (HT) ZnO films with the thickness of 0.7 μm at 550 °C. A ZnO buffer layer with a growth temperature of 450 °C (450 °C-buffer sample) was found to greatly enhance the crystalline quality of the top ZnO film compared to others. The root mean square (RMS) roughness (3.3 nm) of its surface is the smallest, compared to the 350 °C-buffer sample (6.7 nm), the 550 °C-buffer sample (7.4 nm), and the sample without a buffer layer (6.8 nm). X-ray diffraction (XRD), photoluminescence (PL) and Raman scattering measurements were carried out on these samples at room temperature (RT) in order to characterize the crystalline quality of ZnO films. The preferential c-axis orientations of (0 0 2) ZnO were observed in the XRD spectra. The full-width at half-maximum (FWHM) value of the 450 °C-buffer sample was the narrowest as 0.209°, which indicated that the ZnO film with a buffer layer grown at this temperature was better for the subsequent ZnO growth at elevated temperature of 550 °C. Consistent with these results, the 450 °C-buffer sample exhibits the highest intensity and the smallest FWHM (130 meV) of the ultraviolet (UV) emission at 375 nm in the PL spectrum. The ZnO characteristic peak at 438.6 cm−1 was found in Raman scattering spectra for all films with buffers, which is corresponding to the E2 mode.

Tri-Buffer Process: A New Approach to Obtain High-Quality Zno Epitaxial Films on Sapphire Substrates

MBE‐grown ZnO Film on Sapphire Substrate with Double Buffer Layers

Molecular Beam Epitaxy Growth of Single-Domain and High-Quality ZnO Layers on Nitrided (0001) Sapphire Surface

The Roles of Buffer Layer Thickness on the Properties of the ZnO Epitaxial Films

Controlled Growth of Zn-Polar Zno Epitaxial Film by Nitridation of Sapphire Substrate

Growth of high-quality ZnO thin films on (11\bar{2}0) a-plane sapphire substrates by plasma-assisted molecular beam epitaxy

Growth of high quality Zn0.9Mg0.1O films on c-plane sapphire substrates by plasma-assisted molecular beam epitaxy

Effect of Mgo in Zno Films Grown on Nitrided Sapphires

Epitaxial Growth Of Zno On Gan/Sapphire Substrate By Radio-Frequency Magnetron Sputtering

Growth of High-Quality ZnO Thin Films on ( 112̅0 ) A-Plane Sapphire Substrates by Plasma-Assisted Molecular Beam Epitaxy

Growth of High-Quality Epitaxial ZnO Films on (10–10) Sapphire by Atomic Layer Deposition with Flow-Rate Interruption Method

Improved epitaxy of ZnO films by regulating the layers of graphene

Thermal Pretreatment of Sapphire Substrates Prior to Zno Buffer Layer Growth

High-quality AlN Epitaxy on Sapphire Substrates with Sputtered Buffer Layers

High-quality Heteroepitaxial Growth of (3-Ga2o3 with NiO Buffer Layer Based on Mist-CVD

Non-polar A-Plane ZnO Films Grown on R-Al2o3 Substrates Using GaN Buffer Layers

Role of Gallium Wetting Layer in High-Quality Zno Growth on Sapphire(0001) Substrates

Two-Step Growth of MgO Films on Sapphire (0001) Substrates by Radio Frequency Plasma-Assisted Molecular Beam Epitaxy

ZnO growth on Si with low-temperature CdO and ZnO buffer layers by molecular-beam epitaxy

Effect of Sapphire Substrate Pre-Treatment on the Growth of Zno Films

ZnO Growth on Si with Low-Temperature ZnO Buffer Layers by ECR-assisted MBE