Abstract:The influence of coating thickness on laser-induced damage (LID) characteristics of anti-reflection (AR) coatings irradiated by 1064 nm nanosecond laser pulses was investigated. Two HfO2/SiO2 AR coatings with different physical thicknesses, 0.7 and 2.7 mu m, were prepared and tested. To study the effect of coating thickness on a laser-induced damage threshold (LIDT) in isolation, electric field intensities (EFIs) at the substrate-coating interface were kept the same by using proper AR designs. Moreover, 2 nm artificial gold particles with a density of 10 mm(-2) were implanted into the substrate-coating interface to achieve reliable experimental results. An optical microscope (OM) and a scanning electron microscope (SEM) were used for an online LIDT test and offline LID morphology observation, respectively. The typical LID morphology of thicker AR coatings was flat bottom craters with diameters of 20-50 mu m, which can be easily observed by an online OM. For thinner AR coatings, hemispherical craters with diameters down to 1 mu m were found as typical LID morphology by a SEM. However, these tiny craters could not be observed by an online OM. Moreover, such tiny craters did not grow with subsequent pulses, so they did not degrade the functional laser damage resistance of the thin AR coatings. When identified with an online OM, the LIDT of thinner AR coatings is found to be about two times higher than the thicker ones, and large delamination was mainly found as the LID morphology of AR coatings with high fluence. When observed with a SEM, the LIDT of thin AR coatings with tiny craters was over 60% lower than the LIDT of thick AR coatings, which agrees with the model that less energy is required to form smaller LID craters of thinner coatings. (C) 2017 Optical Society of America

Laser damage threshold measurements of 1064nm high-reflection mirrors

Laser damage threshold measurements of 1064 nm high-reflection mirrors

Influence of outmost layer on laser induced damage threshold of 1064nm high-reflection mirrors

Influence of outmost layer on laser induced damage threshold of 1064 nm high-reflection mirrors

Study of Laser Induced Damage of High Reflector at 1064 Nm

Comparative study of Laser induce damage of HfO2/SiO2 and TiO2/SiO2 mirrors at 1064 nm.

Laser-induced Damage of TiO2∕SiO2 High Reflector at 1064Nm

LIDT of HfO 2 /sio 2 HR Films by Different Test Modes at 1064nm and 532Nm

Laser damage resistance of dichroic mirrors at 532nm and 1064nm

Investigation of Fs-Laser Induced Damage on High Reflection Mirrors Used for 800nm Broadband Pulse Compression Gratings

Laser damage growth characteristics of HfO2/SiO2 high reflection film at 1064 nm

Nanosecond pulsed laser damage characteristics of HfO2/SiO2 high reflection coatings irradiated from crystal-film interface.

Characterization of Laser Induced Damage of HR Coatings with Picosecond Pulses

Dual-wavelength investigation of laser-induced damage in multilayer mirrors at 532 and 1064 nm

Nanosecond Laser-Induced Damage of High-Reflection Coatings: Nuv Through Nir

Laser-conditioning Mechanism of ZrO2/SiO2 HR Films with Fitting Damage Probability Curves of Laser-Induced Damage

Influence of Coating Thickness on Laser-Induced Damage Characteristics of Anti-Reflection Coatings Irradiated by 1064 Nm Nanosecond Laser Pulses

Femtosecond Laser Pulse Induced Damage In Thin Films - Art. No. 60281d

Investigation of damage induced by high-power continuous wave laser on SiC-based film

Investigation on Nano-Absorbing Precursors in the Picosecond Regime Via the Comparative Study of HfO2/SiO2 and Ta2O5/SiO2 High-Reflectivity Coating Damage

Laser Damage Properties of Broadband Low-Dispersion Mirrors in Sub-Nanosecond Laser Pulse.