Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Analysis of Transverse Sensitivity in Eight-beam Piezoresistive Micro-accelerometer

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

A piezoresistive micro-accelerometer with high frequency response and low transverse effect

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

Analysis On Twin-Mass Structure For A Piezoresistive Accelerometer

A High-Performance Micromachined Piezoresistive Accelerometer with Axially Stressed Tiny Beams

Modeling and Simulation of A Silicon Integration Tri-Axial Piezoresistive MEMS Accelerometer Chip Used for High Impact Test

A Low Cross-Axis Sensitivity Micro-Grating Accelerometer With Double-Layer Cantilever Beams

Development of a High-Performance Microaccelerometer With Position Independent Pure-Axial Stressed Piezoresistive Beams

Design and Simulation for Tri-Axial Piezoresistive Mems Accelerometer

Design and Simulation of Capacitive, Piezoresistive and Piezoelectric Triaxial Accelerometers Using a Highly Symmetrical Quad-Beam Structure

A Piezoresistive Accelerometer with Axially Stressed Tiny Beams for Both Much Increased Sensitivity and Much Broadened Frequency Bandwidth

Design of a Biaxial High-G Piezoresistive Accelerometer with a Tension–Compression Structure

A Novel Tri-Axial Piezoelectric MEMS Accelerometer with Folded Beams

A Novel Method For Testing Accelerometer Transverse Sensitivity

High Linearity Piezoresistance Micromachining Accelerometer with Low Range

A Piezoresistive Accelerometer with a Novel Vertical Beam Structure