Abstract:Surface roughness affects material life, especially fatigue and wear. This study examines surface mechanical attrition treatment (SMAT) on AA7075‐T6 aluminum alloy, using low‐speed vibration, varied shot amounts, and sizes. SMAT produces smoother surfaces, lowers friction, and improves wear performance, enhancing tribological properties and engineering use. Surface roughness significantly impacts the service life of materials, particularly in relation to fatigue and wear behavior. This study investigates the effects of surface mechanical attrition treatment (SMAT) on the wear performance and surface topography of AA7075‐T6 aluminum alloy. Experimental investigations are conducted using a specially designed vibration table to apply SMAT at low speeds, varying shot amount, and shot diameter. Surface roughness is measured using a 3D optical profilometer, and wear performance is evaluated through friction coefficient, wear rate, and microstructural analysis via scanning electron microscope. The results highlight several key findings. First, SMAT demonstrates the capability to yield smoother surfaces compared to equivalent processes, enhancing performance and applicability in engineering contexts. Second, SMATed samples exhibit increased surface roughness compared to untreated samples, underscoring the influence of SMAT on surface topography and its potential implications for wear resistance and frictional behavior. The comparative analysis shows that SMAT treatment increases surface roughness from 0.14 μm to a maximum of 0.24 μm. Finally, a notable reduction in friction coefficient, up to 22%, is observed in SMATed AA7075‐T6 samples, indicating the effectiveness of SMAT in improving tribological properties and enhancing component longevity subjected to frictional forces.

Wear resistance of NiTi alloy after surface mechanical attrition treatment

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Surface hardening of NiTi shape memory alloy induced by the nanostructured layer after surface mechanical attrition treatment.

Microstructural Evolution in NiTi Alloy Subjected to Surface Mechanical Attrition Treatment and Mechanism

Surface Mechanical Attrition Treatment Induced Phase Transformation Behavior in NiTi Shape Memory Alloy

Dry sliding wear of PM Al-10Ti alloy

Microstructure and Sliding Wear Behavior of PM Alloy Al10Ti after Thermal Exposure

Thermal effects on wear behavior of additively manufactured NiTi shape memory alloys

Corrosion Behavior on Orthopedic NiTi Alloy with Nanocrystalline/amorphous Surface

Microstructure Evolution, Hardness, and Tribological Behaviors of Ti-50.8Ni SMA Alloy with Ultrasonic Surface Shot Peening Treatment

Friction and Wear Resistance of Nanostructured TiNi Shape Memory Alloy

Dry sliding wear of MA/PM Al-10Ti alloy

Effect of Surface Mechanical Attrition Treatment on Surface Topography and Dry Sliding Wear Performance of AA7075‐T6

Contributions of the Particulate Reinforcement to Dry Sliding Wear Resistance of Rapidly Solidified Al-Ti Alloys

Tribology behaviors of Ti–Ni51.5 at% shape memory alloy with different microstructures and textures

Surface Nanocrystallization of Mg-3 Wt.% Li-6 Wt.% Al Alloy by Surface Mechanical Attrition Treatment

Temperature dependence of tribological properties in NiTi shape memory alloy: A nanoscratching study

Sliding and Fretting Wear Behavior of Biomedical Ultrafine-Grained TiNbZrTaFe/Si Alloys in Simulated Physiological Solution

Structural transformations, strengthening, and wear resistance of titanium nickelide upon abrasive and adhesive wear

Effect of aging treatment on microstructure and wear performance of Ni-rich NiTiFe alloy

Analysis of microstructure, mechanical properties, wear characteristics and corrosion behavior of SLM-NiTi under different process parameters