Abstract:For the first time, a powder of W-5Ni-2Fe composition with spherical particles from 15 to 50 microns and a tungsten grain size from 0.5 to 3 microns was obtained using a new technological approach, developed by the authors, based on plasma spheroidization of powder granules made from nanoparticles synthesized in a plasma chemical process. The possibility of using the obtained spheroidized powder W-5Ni-2Fe in the process of selective laser melting (SLM) has been proved. The microstructure, physical, and mechanical characteristics of experimental samples made using SLM technology from the produced W-5Ni-2Fe powder have been studied. The results of the performed studies have shown that the microstructure of experimental samples is extremely dependent on the parameters of the SLM process. The precise choice of the SLM process mode made it possible to obtain a homogeneous structure of experimental samples of tungsten heavy alloy (WHA), with a tungsten grain size of about 1–2 microns, which is much smaller than the tungsten grain size in traditional heavy alloys. This creates prerequisites for increasing the strength characteristics of parts of complex shapes made by the SLM method from such powders. The maximum values of density and hardness of experimental samples obtained in the conducted studies are not worse than the values of samples obtained using traditional liquid-phase sintering technology. It is determined that the main problem of SLM powder W-5Ni-2Fe during investigation is the heterogeneity of the microstructure of massive samples and the formation of micropores and microcracks.

Preparation and Sintering of Nano-Sized W-Ni-Fe Powder by Sol-Spray-Drying Process

Chemical Synthesis of Monodisperse Fe-Ni Nanoparticles Via A Diffusion-Based Approach

Microstructure and mechanical properties of liquid–phase sintered W@NiFe composite powders

Preparation and electrochemical properties of nanocrystalline NiO powder prepared by sol-gel process

Preparation and Sintering Performance of W-Ni/Yb2O3 Composite Materials

Preparation of Ni–Ti composite powder using radio frequency plasma spheroidization and its laser powder bed fusion densification

Preparation of NiAl2O4/Al2O3 composite nanopowder

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

The Preparation of the Highly Dispersed and Nano-sized Nickel Powders

Study on synthesis and structure of mechanically alloyed W-Ni-Fe nanocomposite powders

Preparation of Nanocrystalline Tungsten Powder and Study of Its Sinterability

Method of W-Ni-Fe Composite Spherical Powder Production and the Possibility of Its Application in Selective Laser Melting Technology

Investigations of the nickel promotional effect on the reduction and sintering of tungsten compounds

Characterization and Low-Temperature Sintering of Ni0.5Zn0.5Fe2O4 Nano-Powders Prepared by Refluxing Method

Preparation, sintering behavior and microstructure of Al2O3-Coated Ni powders

A Novel Sol–gel Process to Facilely Synthesize Ni3Fe Nanoalloy Nanoparticles Supported with Carbon and Silica

Sintering Properties and Microstructure of Fe-Ni-Co-based Superalloy Atomized Powder

A novel dissolution-precipitation mechanism during liquid phase sintering and its strengthening effects in W-Ni-Fe alloys with low W contents

Phase transformation and thermal stability of mechanically alloyed W–Ni–Fe composite materials

Properties of Nano-composite Powders of NiCrCoAlY-TiB2 Prepared by High Energy Ball Milling for High Velocity Air Fuel Spraying

Production of Spheroidized Micropowders of W-Ni-Fe Pseudo-Alloy Using Plasma Technology