Abstract:Multi pass spinning forming is one of the major approaches to manufacture rotationally symmetric thin-walled components, which is strongly influenced by the spinnability of materials. But it remains an open question regarding the formability limit in the multi-pass spinning process. According to the spinning experiment phenomena under different spinning passes and thinning rates, a modified GTN model was incorporated into the FE simulation to analyze the damage evolution and cracking mechanism during single-pass tube spinning and multi-pass spinning. The results show that the thinning rate and spinning pass have an important influence on the forming limit of 2024 aluminum alloy. Smaller thinning rates in multi-pass tube spinning led to earlier crack compared to single-pass tube spinning, which was induced mainly by void damage, while the cracking under larger thinning rates was primarily caused by shear damage. When the pass thinning rate reached similar to 21%, no crack occurred at the total thinning rate of 38% in multi-pass spinning, which was much higher than the forming limit (no more than 29.85%) in single-pass spinning. In this case, both the insufficient plastic deformation and low stress triaxiality suppress the damage accumulation, contributing to the increase of the spinnability of materials in multi-pass spin forming. This study provides an effective guidance for establishing the thinning strategy for spin forming practice.

Numerical simulation and experimental research on the multi-pass neck-spinning of non-axisymmetric offset tube

Numerical simulation and experimental study on non-axisymmetric spinning with a groove at the middle of the tube

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

FEM Simulation of Tube Spinning with Non-Symmetric Distribution of Three Rollers

Numerical Simulation of Stagger Spinning of Cylindrical Part with Cross Inner Ribs

Study on the spinning process of thin-walled aluminum alloy vessel head

Spinning deformation mechanism of aluminum alloy cylinder with multi-level stiffeners based on numerical simulation

Mechanism of Increasing Spinnability by Multi-Pass Spinning Forming – Analysis of Damage Evolution Using a Modified GTN Model

Study on Counter-Roller Spinning Technology of Large Diameter Aluminum Alloy Cylindrical Parts

Research on Material Flow Rule of Backward Tube Spinning Process

A Study of 3D Finite Element Modeling Method for Stagger Spinning of Thin-Walled Tube

Finite element simulation of backward ball spinning of thin-walled tube with longitudinal inner ribs

Effect of Multi-Pass Power Spinning on Microstructure Homogenization and Mechanical-Property Strengthening of Ti2AlNb-Based Alloy Using Welded Tube Blank

Study on Numerical Simulation for Control of Winding Process of Thin Wall Spiral Tube

Experimental and Numerical Investigation on Axial Hydro-Forging Sequence of 6063 Aluminum Alloy Tube

Numerical simulation of spinning forming of A356 aluminum alloy hub using dual spinning rollers

Numerical simulation of hot ball spinning of NiTi shape memory alloy tube