Abstract:A 3–5 GHz broadband flat gain differential low noise amplifier (LNA) is designed for the impulse radio ultra-wideband (IR-UWB) system. The gain-flatten technique is adopted in this UWB LNA. Serial and shunt peaking techniques are used to achieve broadband input matching and large gain-bandwidth product (GBW). Feedback networks are introduced to further extend the bandwidth and diminish the gain fluctuations. The prototype is fabricated in the SMIC 0.18 μm RF CMOS process. Measurement results show a 3-dB gain bandwidth of 2.4–5.5 GHz with a maximum power gain of 13.2 dB. The excellent gain flatness is achieved with ±0.45 dB gain fluctuations across 3–5 GHz and the minimum noise figure (NF) is 3.2 dB over 2.5–5 GHz. This circuit also shows an excellent input matching characteristic with the measured S11 below −13 dB over 2.9–5.4 GHz. The input-referred 1-dB compression point (IP1dB) is −11.7 dBm at 5 GHz. The differential circuit consumes 9.6 mA current from a supply of 1.8 V.

Design of a Fully Differential CMOS LNA for 3.1–10.6 GHz UWB Communication Systems

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Low Power High Gain UWB LNA in 0.18-Μm CMOS

A High-Gain Differential Cmos Lna For 3.1-10.6 Ghz Ultra-Wideband Receivers

Fully Differential CMOS LNA and Down-Conversion Mixer for 3-5 GHz MB-OFDM UWB Receivers

A 0.18 μm CMOS 3–5GHz switched gain low noise amplifier for UWB system

A Fully Integrated LNA for 3-5 GHz UWB Wireless Applications in 0.18-&Amp;#x03bc;m CMOS Technology

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Design of Ultra-Wideband LNA with 3.6 ± 0.4 Db NF and 15.9 ± 1.1 Db Gain

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

Analysis And Design Of A Cmos Low Noise Amplifier For 3-5 Ghz Uwb Systems

Design of an Ultra-Wideband CMOS Low Noise Amplifier

Analysis and design of a fully integrated IMT-Advanced/UWB dual-band LNA

A 2.99 Db NF 15.6 Db Gain 3-10Ghz Ultra-wideband Low-Noise Amplifier for UWB Systems in 65 Nm CMOS

1.8-V 3.1-10.6-GHz CMOS low-noise amplifier for ultra-wideband applications

A 0.18 Μm CMOS 3–5 GHz Broadband Flat Gain Low Noise Amplifier

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

An ultra-wide-band 3.1–10.6GHz LNA design in 0.18μm SiGe BiCMOS

A 3.1-5GHz high and flat gain UWB LNA

A Single-in-differential-out CMOS RF Front-End for UWB 6&#x2013;9ghz Applications