Abstract:This study investigated defect formation and strain distribution in high-Mg-content Al-Mg alloys during normal rolling and cross-rolling processes. The finite element analysis (FEA) revealed the presence of wave defects and strain localization-induced zipper cracks in normal cold rolling, which were confirmed by the experimental results. The concentration of shear strain played a significant role in crack formation and propagation. However, the influence of wave defects was minimal in the cross-rolling process, which exhibited a relatively uniform strain distribution. Nonetheless, strain concentration at the edge and center regions led to the formation of zipper cracks and edge cracks, with more pronounced propagation observed in the experiments compared to FEA predictions. Furthermore, texture evolution was found to be a crucial factor affecting crack propagation, particularly with the development of the Goss texture component, which was observed via electron backscattered diffraction analysis at bending points. The Goss texture hindered crack propagation, while the Brass texture allowed cracks to pass through. This phenomenon was consistent with both FEA and experimental observations. To mitigate edge crack formation and propagation, potential strategies involve promoting the formation of the Goss texture at the edge through alloy and process conditions, as well as implementing intermediate annealing to alleviate stress accumulation. These measures can enhance the overall quality and reliability of Al-Mg alloys during cross-rolling processes. In summary, understanding the mechanisms of defect formation and strain distribution in Al-Mg alloys during rolling processes is crucial for optimizing their mechanical properties. The findings of this study provide insights into the challenges associated with wave defects, strain localization, and crack propagation. Future research and optimization efforts should focus on implementing strategies to minimize defects and improve the overall quality of Al-Mg alloys in industrial applications.

Surface Inclusions and Their Evolution on Strip Rolled on CSP Line and in Following Cold Rolling Process

Mechanism of Black Strips Generated on Surface of CSP Hot-Rolled Silicon Steel

Study on "Black Line" on the Edge of SPHC Hot-rolled Strip

Study on Rolling Defects of Al-Mg Alloys with High Mg Content in Normal Rolling and Cross-Rolling Processes

Analysis on Occurence and Cause of Linear Defectson Cold-rolled Sheet

Analysis of Surface Sliver Defect on Cold Rolled and Cold Rolled Galvanizing Sheet

Characteristics and Hereditary Harm of the Surface Inclusion in Cast rolling Aluminum Strip

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Analysis and control of inclusion defects on surface of LCAK hot-rolled coil

Cause Analysis and Precaution of Striation Defects of St12 Cold Rolled Coil

Analysis on peeling defects of cold-rolled sheet and its influencing factor

The production and formal control of sulphide inclusions in steel

Analysis and control of feathering defects on surface of cold rolled thin gauge high strength steel

Surface cellular salient defects of galvanized steel sheets

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Formation Mechanism of CaS-Bearing Inclusions and the Rolling Deformation in Al-Killed, Low-Alloy Steel with Ca Treatment

Study on quarter-wave generation mechanism in DP980 steel during cold rolling

Rail rolling contact fatigue formation and evolution with surface defects

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface

Microstructures and textures in cold-rolled aluminium strip