Abstract:The effect of reduction partitioning in two-stage cold rolling on the microstructure, texture, and ridging resistance of ferritic stainless steel was investigated to obtain the optimal process to improve the surface quality of the sheets. In the present study, four different cold rolling processes were employed: conventional cold rolling without intermediate annealing (i.e., Route 1) and two-stage cold rolling with three different reduction partitionings (i.e., Routes 2, 3, and 4). In Route 1 final annealed sheets, significant surface ridging defects were observed due to relatively large grain sizes, pronounced oriented grain colonies and size grain colonies. The ridging resistance of the final annealed sheets in the two-stage cold rolling process improved compared to Route 1. In two-stage cold rolling, the optimal ridging resistance was obtained when the first-stage cold rolling employed a 50% reduction and the second-stage cold rolling employed an 80% reduction. The results show that the texture is mainly shifted from α-fiber orientation to γ-fiber orientation. Additionally, decreasing the {001} orientation volume fraction, improving the uniformity along the γ-fiber texture, increasing the γ-fiber intensity, and decreasing the average grain size of the final annealed sheets can improve the ridging resistance of the sheets. Moreover, eliminating orientation and size of grain colonies to achieve a uniform distribution is a key factor in improving the ridging resistance of the sheets. The appropriate reduction partitioning is a crucial factor in determining the ridging resistance of two-stage cold rolling final annealed sheets. Graphical

Analysis on peeling defects of cold-rolled sheet and its influencing factor

Analysis on Occurence and Cause of Linear Defectson Cold-rolled Sheet

Analysis of Surface Sliver Defect on Cold Rolled and Cold Rolled Galvanizing Sheet

Analysis On Causing Of Cold-Rolled Steel Hole Defect And Improvement Measures

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Cause Analysis and Precaution of Striation Defects of St12 Cold Rolled Coil

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface

Surface Peeling Reason of Hot-Rolled 06cr17ni5n Austenitic Stainless Steel Plate

Formation reason and control measures of surface quality defects of cold rolled steel sheet for galvanization

Reason for Edge Cracking of Cold-Rolled 55Mn Strip Steel and the Cold-rolling Control Measures

Surface cellular salient defects of galvanized steel sheets

Surface Inclusions and Their Evolution on Strip Rolled on CSP Line and in Following Cold Rolling Process

Micro Crack of Aluminum Sheet During Cold Rolling

The Causes and Control of Longitudinal Edge Cracks of the Plate

Analysis of the characteristics and formation causes of granophyric defect on the surface of ship plate

Analysis and control of feathering defects on surface of cold rolled thin gauge high strength steel

Steel Edge Cracking Analysis and Improvement Measures

Effects of Reduction Partitioning in Two-Stage Cold Rolling on the Surface Ridging Resistance of Ferritic Stainless Steel

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Effect of Rolling Reduction and Temperature on the Oxide Scale of Hot Rolled Mild Steel Strip

Microstructures and textures in cold-rolled aluminium strip