Linear Dependency of Al-mole Fraction with Group-Iii Precursor Flows in AlxGa1−xN (0≤x≤1) Deposition by LP OMVPE

A. Rice,R. Collazo,J. Tweedie,J. Xie,S. Mita,Z. Sitar
DOI: https://doi.org/10.1016/j.jcrysgro.2009.09.011
IF: 1.8
2010-01-01
Journal of Crystal Growth
Abstract:AlxGa1−xN/GaN heterostructures (0≤x≤1) were deposited on (0001)-sapphire by low-pressure (20Torr) organometallic vapor phase epitaxy utilizing a range of group-III precursor and NH3 flow rates and a deposition temperature of 1050°C. The Al-mole fraction of AlxGa1−xN layers was controlled by variations in the molar flows of triethylgallium (fTEG) and trimethylaluminum (fTMA). Characterization by X-ray diffraction confirmed that increasing the fTMA/fTEG ratio during deposition resulted in increased Al-mole fraction of AlxGa1−xN layers. A linear relationship between the experimental Al-mole fraction of AlxGa1−xN layers and the group-III precursor flows was obtained if a correction factor γ was introduced such that x=γfTMA/(γfTMA+fTEG). This correction factor was found to be independent of group-III precursor flows but dependent on NH3 partial pressure. The value of γ for these experiments decreased from 1.4 to 1.0 when the NH3 partial pressure was increased from 0.8 to 16.0Torr during AlxGa1−xN deposition. The growth rate of AlxGa1−xN layers was found to be a linear combination of the independent AlN and GaN growth rates when equivalent fTMA and fTEG were utilized under the same deposition conditions.
What problem does this paper attempt to address?