Abstract:CaCu3Ti4O12 (CCTO) ceramics with smaller grain size usually show a low dielectric constant by using the conventional sintering method. In this work, the pure CCTO ceramics with smaller grain size prepared by the spark plasma sintering method (SPS) present the giant dielectric constant (ε′) over a wide temperature range. The dense CCTO ceramics have been rapidly fabricated by a sol–gel process and the SPS method at different sintering temperatures. The XRD patterns indicate a single CCTO phase with cubic perovskite structure in SPS-CCTO ceramics. The SEM images demonstrate that the average grain size of the SPS-CCTO ceramics increases from about 2.23(± 1.56) μm to 4.68(± 2.45) μm with the increases of the SPS sintering temperature from 800 to 900 °C. The obvious electrically heterogeneous characteristics in these SPS-CCTO ceramics are affirmed by the complex impedance spectroscopy analysis. The highest dielectric constant of 1.58 × 104 at 103 Hz is found in SPS-CCTO3 (900 °C) ceramics, and the temperature coefficients of the dielectric constant Δε′ in SPS-CCTO1 (800 °C) and SPS-CCTO2 (850 °C) ceramics with the high ε′ values are less than ± 15% (Δε′ < ±15%) over a temperature range of − 30 to 80 °C; the high dielectric constant is due to the phenomenon of Rg ≪ Rgb based on the internal barrier layer capacitance (IBLC) effect. The larger nonlinear coefficient of 9.07, as well as the enhanced breakdown field of 3257 V/cm are achieved in SPS-CCTO1 ceramics, which is attributed to the increased grain boundary resistance and the Schottky barrier at grain boundary regions. These results indicate that the SPS method is an effective way to control the grain size and improve the electrical properties of the CCTO ceramics for energy storage application.

Sol–gel Derived CaCu3Ti4O12 Ceramics: Synthesis, Characterization and Electrical Properties

Structure, Properties, and Impedance Spectroscopy of CaCu3Ti4O12 Ceramics Prepared by Sol-Gel Process: Structure, Properties, and Impedance Spectroscopy of CaCu3Ti4O12

Dielectric Properties and IV Characteristic of CaCu_3Ti_4O_(12)-MgTiO_3 Composite Ceramic Synthesized by Sol-Gel Method

Structure, Properties, And Impedance Spectroscopy Of Cacu3ti4o12 Ceramics Prepared By Sol-Gel Process

Electrical Heterogeneity in CaCu3Ti4O12 Ceramics Fabricated by Sol–gel Method

GIANT DIELECTRIC CONSTANT MATERIAL CaCu3Ti4O12 PREPARED BY SOL-GEL METHOD

Enhanced Extrinsic Dielectric Response of TiO2 Modified CaCu3Ti4O12 Ceramics

Structural and dielectric properties of CaCu3Ti4O12 synthesized by sol–gel method

Development of CaCu3 Ti4 O12 Ceramics with Giant Dielectric Constant

Giant Dielectric Permittivity and Non-Linear Electrical Behavior in CaCu3Ti4O12 Varistors from the Molten-Salt Synthesized Powder

Rapid Fabrication and Improved Electrical Properties of CaCu3Ti4O12 Ceramics by Sol–gel and Spark Plasma Sintering Techniques

Synthesis of Calcium Copper Titanate Ceramics Via the Molten Salts Method

Grain Size Effect on the Dielectric and Non-Ohmic Properties of CaCu3Ti4O12 Ceramics Prepared by the Sol-Gel Process

CaCu3Ti4O12 (CCTO) ceramics for capacitor applications

Microwave-Assisted Synthesis of High Dielectric Constant CaCu 3 Ti 4 O 12 from Sol–Gel Precursor

CaCu3Ti4O12 Ceramics from Basic Co-Precipitation (BCP) Method: Fabrication and Properties

Microstructure and electrical properties of sol–gel derived Ni-doped CaCu3Ti4O12 ceramics

Strontium doped CaCu3Ti4O12 ceramics with very low dielectric loss synthesized by the sol–gel method

Electrical Conduction and Dielectric Properties of the CaCu_3Ti_4O_(12) Ceramics Synthesized by SPS

Dielectric Properties of Zr-Doped CCTO Based Ceramics Prepared via Sol-Gel Method

Preparation and characterization of CaCu 3 Ti 4 O 12 powders by non-hydrolytic sol–gel method