Abstract:Hot rolling of steels represents one of the most critical steps to achieve finished products with high surface quality. The increasing productivity added to the rising customer requirements result in more and more severe scheduling rules for the HSM. Strip surface aspect is very important in terms of HSM operation costs and productivity limitation. Among all surface defects, the most crippling comes from the oxide scale formed at the surface of the steel during the hot rolling, at the entry of the finishing mill (last part of the hot strip mill): the secondary scale, mechanical behaviour of which is still poorly known. The secondary scale may fracture under the stresses imposed by the successive rolling passes, and can be embedded in the steel strip surface: this defect is called "rolled-in scale defect". In addition, the extrusion of the subjacent metal inside the oxide cracks induces large local modifications of friction and heat transfer conditions. Consequently, a precise description of oxide scale deformation mechanisms is necessary to better define the boundary conditions in a roll bite and to better understand the initiation mechanisms of rolled-in scale defects. Our scientific objective is then to provide a realistic physical and numerical model to simulate the oxide scale flow in the roll bite and in particular, its damage. After the presentation of the industrial process and the context of this study, the physical and mechanical properties of the oxide scale in the finishing mill are investigated. We introduce the Forge2® finite element software, selected for this study to simulate the oxide scale behaviour in a finishing mill stand. The numerical developments performed to simulate the different kinds of oxide damage are described. Three mechanical tests have been selected to approach the solicitations undergone by the oxide scale at the entry of the roll gap, suspected to be critical for damage: the 4-point hot bending test, the hot tension test and the hot plane strain compression test. A numerical study is performed in parallel. Based on constitutive data obtained from these three mechanical tests, the mechanical description of a rolling stand is sufficient for satisfactory simulation of the industrial process.

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface

Analysis of the characteristics and formation causes of granophyric defect on the surface of ship plate

Formation reason and control measures of surface quality defects of cold rolled steel sheet for galvanization

Cause Analysis and Precaution of Striation Defects of St12 Cold Rolled Coil

Analysis on peeling defects of cold-rolled sheet and its influencing factor

Mechanism of Black Strips Generated on Surface of CSP Hot-Rolled Silicon Steel

Surface cellular salient defects of galvanized steel sheets

Process Optimization of Straightening Scale Breaking and Pickling Process for Residual Oxide Scale on Surface of Hot Rolled Strip Steel

Effect of Oxide Scale Microstructure on Atmospheric Corrosion Behavior of Hot Rolled Steel Strip

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Experimental Study on Adhesion of Oxide Scale on Hot-Rolled Steel Strip

The Causes and Control of Longitudinal Edge Cracks of the Plate

Local strain analysis of the tertiary oxide scale formed on a hot-rolled steel strip via EBSD

Effect of microstructure and microtexture evolution of oxide layer over J82B steel on mechanical descaling properties

A Review of Microstructure and Microtexture of Tertiary Oxide Scale in a Hot Strip Mill

The effect of oxide scale of stainless steels on friction and surface roughness in hot rolling

A Study of the Mechanism of Formation of Composite Oxide Scale on Heat-Resistant Steel 25Cr18Ni9Si2

Experimental study and numerical simulation of iron oxide scales mechanical behavior in hot rolling

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Analysis of Discoloration Mechanism for Electrical Equipment Silver-Plated Surface and Processing

Factors Affecting the Development of Oxide Scales on Austenitic Stainless Steels during Hot Rolling in Steckel Mills