Abstract:The oxidation behavior of Si-containing steels at high temperature has been the subject of numerous investigations. In many cases, the addition of Si to the steel in sufficient amounts to form an external film of SiO2 or other Si-rich oxide on the steel surface has resulted in extremely slow oxidation rates. However, the steel in which Si content is insufficient forms an external scale and an internal scale on the steel surface and a subscale in the steel interior which are less protective.In order to suppress the growth of the scales on the hot slab which causes surface bruise of hot rolled Si-containing steel sheets, many researchers paid attention to the de-scaling characteristics of Si-containing steels. However, the effects of Si content on the oxidation kinetics, scale composition and scale structure, especially three-dimensional scale morphology formed on the Si-containing steels at high temperatures are not necessarily understood adequately. In this study, the high-temperature oxidation behavior and scale morphology of (0, 0.5, 1.5, 3.0 mass%) Si-containing steels exposed to the flowing air and the LNG combustion gas atmosphere at 1373K or 1473K were investigated. The external scale and the internal scale formed on Si-containing steels were composed of the laminated α-Fe2O3 and Fe3O4 and the mixture of FeO and Fe2SiO4, respectively. The subscale may be composed of vitreous SiO2. The kinetics of the external and internal scale formation were followed by parabolic rate laws. The SEM images of the three-dimensional subscale extracted from the oxidized steels by means of an organic solvent system dissolution technique showed that an intergranular oxide formed thin walls along not only grain boundaries but also twin boundaries of the steel matrix and an intragranular oxide formed isolated particles in the steel grains near the internal scale.

Process Optimization of Straightening Scale Breaking and Pickling Process for Residual Oxide Scale on Surface of Hot Rolled Strip Steel

Comparative Study of Structure and Pickling Characteristics of Oxide Scale Formed on Strips Produced by TSCR and Conventional Process

Reduction of Oxide Scale with Hydrogen

High-temperature Oxidation Behavior and Scale Morphology of Si-containing Steels

Influence of Controlling Rolling and Cooling on Oxide Scale of 65Mn Steel for Metallurgy Saw Blade

Microstructural Study and Residual Stress Measurement of a Hot Rolling Work Roll Material During Isothermal Oxidation

Mechanism of Black Strips Generated on Surface of CSP Hot-Rolled Silicon Steel

Effect of Rolling Reduction and Temperature on the Oxide Scale of Hot Rolled Mild Steel Strip

Effect of Oxide Scale Microstructure on Atmospheric Corrosion Behavior of Hot Rolled Steel Strip

Surface Roughness Transformation and Deformation of the Scale in Hot Rolling

High-Temperature Oxidation and Subscale Morphology of Si Containing Steels

Experimental Study on Adhesion of Oxide Scale on Hot-Rolled Steel Strip

Efficient Recycling and Utilization Strategy for Steel Spent Pickling Solution

Study on the effect of element enrichment on the surface of high-strength pickling steel on the film-forming performance of phosphating film

Isothermal Structure Transformation and Kinetics Behavior of Oxide Scale on Low Carbon Steel

Tribological Analysis of Oxide Scales During Cooling Process of Rolled Microalloyed Steel

Influence of Oxide Scales on the Corrosion Behaviors of B510L Hot-Rolled Steel Strips

Effect of carbon on isothermal reduction of high-strength steel oxide scale in 30%H2–N2 atmosphere

The Optimal Design for the Production of Hot Rolled Strip with “tight Oxide Scale” by Using Multi-objective Optimization

Pickling Behavior of Water Quenched High Strength Steel Plates and Effect Evaluation of Corrosion Inhibitors

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface