Abstract:Due to moisture in the ore, auxiliary material, and ladle refractory material, the hydrogen element is easily enriched in molten steel. In the metallurgy process, some hydrogen atoms form bubbles and are removed by gravity, whearas others solidify in the strand and remain in the produced steel. When the hydrogen content reaches a certain critical value, the enriched hydrogen atoms congregate to produce a white spot, which greatly reduces the strength and toughness of the steel product, and leads to brittle fracture during its service period. At present, the RH (Ruhrstahl–Heraeus) and VD (vacuum degasser) refining processes are commonly applied in steel plants, which can reduce the hydrogen content to less than 2×10−6. With the demand for high quality steel, the hydrogen content must be further decreased, so hydrogen diffusion in solid steel during the annealing process is gradually attracting increasing attention. In this study, a two-dimensional model was built to investigate the characteristic of dehydrogenation in the bloom annealing process of rail steel. Moreover, the effect of annealing temperature and annealing time on hydrogen diffusion were analyzed, and the annealing parameters were optimized. During the dehydrogenation annealing process, the hydrogen content at the corners and edges of the bloom are found to decrease rapidly, while that in the center of the strand begin to decrease in the later heating stage. As the annealing temperature increases, the starting point of dehydrogenation in the bloom center moves ahead and the maximum dehydrogenation rate increases significantly. With the extension of the soaking period, the central hydrogen content of bloom decreases significantly, but the increase rate of the dehydrogenation gradually decreases. By optimizing the bloom annealing parameters, the hydrogen content in the bloom can be steadily reduced to 0.6×10−6, which fully meets the requirement of high quality steel production.

Effect of carbon on isothermal reduction of high-strength steel oxide scale in 30%H2–N2 atmosphere

High-efficiency reduction behavior for the oxide scale formed on hot-rolled steel in a mixed atmosphere of hydrogen and argon

Reduction of Oxide Scale with Hydrogen

Effect Of Cold Rolling Before Hydrogen Reduction On Reduction Behavior And Morphologies Of Oxide Scale On Hot-Rolled Low-Carbon Steel

Isothermal Reduction Behavior of Oxide Scale on the Surface of Hot‐Rolled Strip Steel Under Different Hydrogen Concentrations

Numerical Simulation of Dehydrogenation Annealing in Bloom

Isothermal Reduction of Oxide Scale on Hot-Rolled, Low-Carbon Steel in 10 Pct H 2 -Ar

New steelmaking process based on clean deoxidation technology

Study on the reduction of Fe2O3 pellets by CO-CO2 and H2-H2O: Reaction kinetics and pore network model

Hot-Dip Galvanizing of Carbon Steel after Cold Rolling with Oxide Scale and Hydrogen Descaling

Investigation into Recycling of Iron Oxide Scale on H13 Steel by Low‐Temperature Carbothermal Reduction Method

Oxide Scale Formation on Low-Carbon Steels in Future Reheating Conditions

A Laboratory Study of the Reduction of Iron Oxides by Hydrogen

Investigation of (H2–H2O) partial pressure on the gas-based reduction of fine iron ore in mixed gases (H2–H2O–CO–CO2–N2)

Clean iron production through direct reduction of mineral iron carbonate with low-grade hydrogen sources; the effect of reduction feed gas composition on product and exit gas composition

The Direct Reduction of Iron Ore with Hydrogen

Studies on the Reduction Behavior of Iron Oxide Pellet Fines with Hydrogen Gas: Mechanism and Kinetic Analysis

Oxidation Behaviour of Steel During hot Rolling by Using TiO2-Containing Water-Based Nanolubricant

Hydrogen steelmaking. Part 1: Physical chemistry and process metallurgy

Effect of Rolling Reduction and Temperature on the Oxide Scale of Hot Rolled Mild Steel Strip

Influence of microstructure and atomic-scale chemistry on iron ore reduction with hydrogen at 700°C