Abstract:The phase transformation of the oxide scale that forms on hot-rolled steel strips during cooling is one of the most important phenomena, which determines the surface quality of the strips, because the properties of the oxide scale, such as spallation resistance, crack initiation, and propagation, and pickling behavior, are strongly dependent on the oxide scale microstructure. To obtain steel strips with high surface quality, it is crucial to understand the microstructural development of the oxide scale. In this paper, a thermogravimetric analyzer was used to study the isothermal structure transformation behavior of FeO formed at high temperature in an inert gas (Ar) at 300-550 degrees C for 1 000-15 000 s. Meanwhile, the isothermal dynamic model of FeO eutectoid transformation was established based on the JMAK equation combined with experimental data. The experimental results show that the oxide scale structure of the sample after pre-oxidation is composed of Fe2O3, Fe3O4, and FeO. At 300 degrees C and 550 degrees C, only the pro-eutectoid structure is formed in the oxide scale, but no eutectoid structure is formed. When the isothermal temperature is in the range of 350-500 degrees C, both pro-eutectoid structure and eutectoid structure are formed in the oxide scale. With the extension of isothermal time, the eutectoid reaction continues until the complete decomposition of FeO. In addition, the FeO eutectoid transformation isothermal dynamics model was used to predict the eutectoid structure content of FeO eutectoid decomposition under different isothermal conditions, and the experimental data were compared with the predicted results, which verified the high prediction accuracy of the model.

A Study of the Mechanism of Formation of Composite Oxide Scale on Heat-Resistant Steel 25Cr18Ni9Si2

High‐Temperature Oxidation of 60si2mn Spring Steel in Dry Air and Wet Air: Insights from an Experimental and First‐Principles Study

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

Isothermal Structure Transformation and Kinetics Behavior of Oxide Scale on Low Carbon Steel

Effect of aluminium and silicon on high temperature oxidation resistance of Fe-Cr-Ni heat resistant steel

Oxidation Kinetics and Spallation Model of Oxide Scale during Cooling Process of Low Carbon Microalloyed Steel

Descaling Abilities of Two Low-Alloy High-Strength Steels Under Different Heating Processes

Morphology and Buckling of the Oxide Scale after Fe–9Cr Steel Oxidation in Water Vapor Environment

Characterization of Oxide Scales Formed on Plain Carbon Steels in Dry and Wet Atmospheres and Their Eutectoid Transformation from FeO in Inert Atmosphere

Analysis of the Oxidation Behavior and Formation of an Extremely Thin Oxide Layer with a Novel Hot-Stamped Steel

Investigation of oxide scale formation and internal oxidation of an Fe-based coating at 500 °C and 600 °C

Experimental Study on Adhesion of Oxide Scale on Hot-Rolled Steel Strip

Microstructure understanding of high Cr-Ni austenitic steel corrosion in high-temperature steam

Analysis of oxide scales on oxidised EN 1.4509 ferritic stainless steel catalyst support by scanning electron microscopy

Revealing the Oxidation Mechanism of Ferritic Heat Resistant Steel in High-Temperature Flue Gas

Analysis of Oxide Layer Formation During Oxidation of AISI 4140 Steel at 1000 °C over Exposure Time

High-temperature oxidation behavior of 9Cr-5Si-3Al ferritic heat-resistant steel

Phase Transformation Behavior Of Oxide Scale On Plain Carbon Steel Containing 0.4 Wt.% Cr During Continuous Cooling

New insights into the oxidation mechanisms of a Ferritic-Martensitic steel in high-temperature steam

Microstructural evolution of early-stage oxide film on 15–15Ti austenitic stainless steel under 500 °C steam

Microstructural understanding of the oxidation of an austenitic stainless steel in high-temperature steam through advanced characterization