Abstract:Abstract The torque transfer capability as well as long-term endurance are essential for wet multi-plate clutches. The quality of the torque transmission process largely depends on the tribological system consisting of friction pairing, lubricant and applied loads. The requirements on friction linings in wet multi-plate clutches increase continuously due to stricter CO 2 reduction regulations and the demand of higher power densities. There is a lack of published data and information about the friction behavior of modern Carbon friction linings in wet multi-plate clutch applications, although these friction materials have successfully proven their performance capabilities over the last two decades in synchronizers. Therefore, this article presents results from experimental studies on the friction behavior of innovative Carbon friction linings carried out on a component test rig. Friction screening tests were performed with Carbon-fiber reinforced plastic (CFRP) and Carbon-fiber reinforced Carbon (C/C) linings in brake and constant slip operation. Furthermore, our research included long-term tests with different lubricants (engine/marine/tractor oil). Results show that modern Carbon friction linings can offer advantages over other materials. In the friction screening (brake and constant slip operations) and long-term tests, the torque transfer capability of both friction linings is very stable, even at high specific loads—sliding velocities near 30 m/s and axial pressures of 2.5 MPa. Influences of sliding velocity, pressure and lubricant on the friction performance are presented. Furthermore, the gradient of the Coefficient of Friction (CoF) curve usually decreases at the end of the engagement to enable good control and shift comfort.

The Influence of Surface Treatment Methods of Separate Plates on Friction Characteristics of Paper-based Wet Clutches

Improvement of Friction Characteristics of Paper-based Wet Clutches by Laser-texturing of Separator Plates

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Influences of Surface Texture on the Friction Characteristics of Powder Metallurgy Clutch Disks

Influence of the steel plate on the friction behavior of automotive wet disk clutches

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Effect of surface modification on friction characteristics of sliding bearings: A review

Influence of the steel disk on the NVH behavior of industrial wet disk clutches

Friction behavior of innovative carbon friction linings for wet multi-plate clutches

The performance of Cu-based friction material in dry clutch engagement

INFLUENCE OF SURFACE POLISHING ON THE FRICTION BEHAVIORS OF NBR

Influence of concave-convex composite texture on the tribology and transmission performance of wet clutch couples

Study on Spline Stress of Separator Plates in a Wet Multi-Plate Clutch

Combined Effect of a Laser Cladded Coating and Surface Texture on Tribological Performance Under Dry Sliding and Starved Lubrication

Effects of Surface Texturing and Laminar Plasma Jet Surface Hardening on the Tribological Behaviors of GCr15 Bearing Steel

Effect of Triangular Texture on the Tribological Performance of Die Steel with Tin Coatings under Lubricated Sliding Condition

Study on the engagement characteristics of wet multi-plate friction clutch based on separating spring

Friction behaviors of rough chromium surfaces under starving lubrication conditions

Effect of Surface Texture on the Tribological Behavior of Sliding Electrical Contact Interface

Simulation and Experimental Validation of the Effect of Surface Texture on Fluid Film Formation

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions