Abstract:With the development of surface precision machining technology and extensive studies on lubrication and friction reduction,the use of surface texture to reduce friction has attracted widespread attention,but few studies have considered the influence of surface roughness on lubrication characteristics.By employing the computational fluid dynamics(CFD)simulation method,the lubrication models with rectangular textures and the introduction of rough asperity structures at the same time are established.The effects of the corresponding structure parameters on the lubrication performance of textured and roughed surfaces are studied under water lubrication conditions.Our results suggest that the adjustment of geometric parameters on the micro-/nano-structured surfaces can influence the load-bearing capacity of the water lubrication film,thus affecting the hydrodynamic lubrication performance on the surface.In addition,the generation of vortex in the micro-textures can bring changes in vorticity,which causes energy dissipation and affects frictional forces.In the lubrication model with rectangular textures,optimal hydrodynamic lubrication performance is obtained under the appropriate depth ratio H=0.6.Meanwhile,the corresponding lubrication performance can be enhanced by increasing the width ratio(W)of surface texture.After introducing random asperity structures on the micro-textured surface with a standard deviation δ=0.5,the bearing capacity is increased by 44%,and the friction coefficient is reduced by 30.9%.Moreover,the introduction of half-sine rough asperity structures can only result in relatively minor differences in the lubrication performance,i.e.the changes of bearing capacity and friction coefficient are less than 10%.However,the introduction of compound hierarchical structure consisting of random asperity structures and half-sine rough asperity structures can result in an increase in the corresponding bearing capacity by 42%and a reduction in the friction coefficient by 31.1%,which implies a significant enhancement in the hydrodynamic lubrication performance.

Simulation and Experimental Validation of the Effect of Surface Texture on Fluid Film Formation

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication

Experimental Verification of Simulation Analysis Method on Antifriction and Lubrication Performance of Surface Texture

Effect of Lubricant Infiltration into the Groove-Like Surface Texture on the Friction Response of the Textured Stainless-Steel Contact Surface

Simulation Study and Experimental Verification of Surface Texture Induced Cavitation Effect

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Experimental Investigation on Effects of Surface Texturing on Lubrication of Initial Line Contacts

Numerical Investigation of the Tribological Performance of Micro-Dimple Textured Surfaces under Hydrodynamic Lubrication

The Effect of Surface Texturing on Reducing the Friction and Wear of Steel under Lubricated Sliding Contact

Evaluation Method and Experimental Verification of Hydrodynamic Lubrication Performance of Different Texturing

The simulation of asymmetric micro-textures on the lubrication characteristics of sliding friction pairs

Effect of Different Textured Surfaces on Lubricating Characteristics of Area Contact Friction Pairs.

Development of low-cost deformation-based micro surface texturing system for friction reduction

Effect of Surface Texturing on Lubrication Performance of Ball - on - Disc Point Contacts

Study on the mixed lubrication of rough planar extrusion considering surface texture

Numerical Simulation on the Lubrication Performance of Surface Textured Piston Rings

Study of the Friction and Wear of Dimple Textured Surfaces Based on Mixed Elastohydrodynamic Lubrication

Fluid Dynamics Simulation on Water Lubricating Performance of Micro-/Nano-textured Surfaces Considering Roughness Structures

Numerical Simulation of Lubrication Performance on Chevron Textured Surface under Hydrodynamic Lubrication

An Analytical And Experimental Parametric Study of Texturing In Slider Bearings Under Hydrodynamic/Mixed Lubrication