Abstract:Detailed knowledge of the influences on the frictional behavior is crucial for reliable operation of safety-relevant, wet-running multi-plate clutches. The breakaway torque is of particular interest for safety-critical applications such as safety brakes and clutches. While influences of the tribological system by variation of friction partners, lubricant and operating conditions are usually the focus of current investigations, the influence of the time of standstill between a preceding tribological load and a subsequent breakaway of the wet disk clutch is not considered. To determine this influence, experimental investigations are carried out on a component test rig. For this purpose, the time of standstill of the clutch is systematically varied after preceding load shifts and the clutch is then broken away. During these investigations, it is shown that the downtime of multi-plate clutches with sinter friction lining has considerable influence on the frictional behavior in the first switching operations after actuation. An influence can already be clearly seen at a standstill time of approximately 15 minutes. An increase in the maximum friction coefficient occurring at the start of the slip switching operation compared with subsequent slip switching operations was observed, which can be attributed to the downtime after a defined preload. Influences of the disk temperature are considered by measuring the outer disk temperature. The influence is attributed to the change of the boundary layer during the standstill. The results provide a contribution to the transferability of investigations of the friction behavior of component test rigs to real applications in which the friction system is exposed to relevant times of standstill and expand the existing knowledge base on test methods.

Influence of the steel plate on the friction behavior of automotive wet disk clutches

Influence of the steel disk on the NVH behavior of industrial wet disk clutches

Friction behavior of innovative carbon friction linings for wet multi-plate clutches

Parametric Analysis of the Drag Torque Model of Wet Multi-Plate Friction Clutch with Groove Consideration

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Einfluss der Stahllamellentopographie auf das Einlaufverhalten nasslaufender Lamellenkupplungen

Experimental investigations of spontaneous damage to wet multi-plate clutches with carbon friction linings

Influences of Surface Texture on the Friction Characteristics of Powder Metallurgy Clutch Disks

Investigating Failure Modes and Performance Impacts of Wet Clutches in Automotive Limited Slip Differentials

The Influence of Surface Treatment Methods of Separate Plates on Friction Characteristics of Paper-based Wet Clutches

Influence of Groove Type on Friction Coefficient of Wet Friction Clutch Pair

Failure Modes of Spontaneous Damage of Wet-Running Multi-Plate Clutches with Carbon Friction Linings

Nonlinear Dynamic Characteristics of Rub-Impact Process at High Circumferential Velocities in No-Load Multiplate Wet Clutch

Einfluss der Stillstandszeit auf das Losreißmoment nasslaufender Lamellenkupplungen

The performance of Cu-based friction material in dry clutch engagement

Analytical simulation of influential parameters affecting grooved wet clutches performance underdisengagement condition

Influence of concave-convex composite texture on the tribology and transmission performance of wet clutch couples

Influences of the Contact State between Friction Pairs on the Thermodynamic Characteristics of a Multi-Disc Clutch

Influence of Material Parameters on the Contact Pressure Characteristics of a Multi-Disc Clutch

Torque capacity of multidisc wet clutch with reference to friction occurrence on its spline connections