Abstract:Tubesheet-flanged joint is usually used in some situations for its detachability, such as some small scale heat exchangers. This type of structure is convenient for maintenance. But leakage will become a major failure mode for flanged joint, especially for heat exchangers with multiple passes. Temperature gradient of different passes may cause non-axisymmetric thermal loading, stress and deformation distribution. In this paper, a detailed three dimensional finite element model of a tubesheet-flanged joint of an oil-water heat exchanger is established with a flexible graphite metallic spiral wound gasket. This kind of gasket has a good compression resilience performance. The compression-unloading curve of gasket under different temperatures are used. The stress and temperature distribution of the joint and gaskets are simulated under preload condition, pressure condition and operation condition. The seating performance are evaluated using gasket compression stress and flange stiffness criteria. The results show that the gasket compression stress distributions under preload and pressure condition are similar. Under operation condition, the gasket compression stress in local area decreases significantly and the gasket compression stress distribution along the circumferential direction becomes non-uniform because of different pass temperature. The Taylor-water method, typically used for flange design, provides a design bolt load for sizing the bolt and flange, does not provide an explicit calculation for the assembly bolt load. At some locations the compression stress is much smaller than minimum seating stress using Taylor-water method to determine bolt preload. However, under preload of half bolt yield strength recommended by ASME PCC-1, all assessment parameters are within the allowable limits.

Safety Assessment Method of Flanged Joints at Elevated Temperature

Experimental study on the performance of cryogenic seal structure with indium

Simulation of Leakage Behavior on Bolted Flanged Connections in Elevated Temperature Service

Advances of Research on Bolted Flange Joints at Elevated Temperature

Time-dependent leakage rate prediction method for bolted flange connection based on equivalent stress-temperature

Sealing Evaluation of Tubesheet-Flanged Joint under Internal Pressure and Non-Axisymmetry Thermal Loading

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Design and analysis of the flange-bolted joint with respect to required tightness and strength

Life Assessment of Non-metallic Gasket Bolted Flanged Connections

Finite ElementAnalysis of Sealing Performance and Stress Intensity of the Flange

An Analysis on the Safety Performance of the Combined Fittings of Straight Tees and Long Radius Elbows

Technical Progress of Safety Assessment and Non-Destructive Measurement for Pressure Vessel at High Temperature (ii)——integrity Assessment Approaches

Safety analysis of pressure piping containing incomplete penetration under combined loads

Mismatch effect on safety assessment of pressure pipe with incomplete penetration defect

Strength and tightness analysis of wellhead flange connections considering ultrahigh-pressure conditions

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

Mechanical properties of butt weldments made with E5515-G electrodes at high temperature

Behavior of bolted joints with metal-to-metal contact type gaskets under bolting-up and loading conditions

Study on Effect of Gasket Stress Distribution on Bolted Flanged Connections

Safety Evaluation for Triangular Supporting Gusset and Supporting Ring at Outside of Absorption Tower