Abstract:Gate valves, which are widely applied in pneumatic conveying systems, are vulnerable to erosion by particles. It is thus important to investigate the erosion in gate valves from the perspective of fluid analysis, and then to predict and improve their lifetimes. The effects of valve geometry and gas-solid flow conditions on valve erosion are investigated. Since a gate valve usually operates fully open to let fluid pass through, the geometry is simplified as a cavity. As gate valves are always placed horizontally in industrial situations, investigated cavities are placed horizontally, and the erosion damage to the bottom half of the aft wall (surface T), which is most likely to be eroded, is studied. A computational fluid dynamics (CFD) based two-way Eulerian-Lagrangian procedue is used to predict the erosion severity. The simulation procedure is validated by comparing the CFD results with those obtained from experiments of a pipe and an elbow, and also with the erosion region of a damaged valve. For convenience, the total erosion ratio, defined as the ratio of the mass eroded on a particular surface to the total particle mass passing through the pipe inlet during the same time, is introduced. The results show that the total erosion ratio of surface T is largely independent of the mass flux ratio, pipe diameter and cavity depth. Meanwhile, the total erosion ratio increases with cavity width and particle diameter, while it decreases with inlet velocity. According to the fitted results, a simple erosion formula is proposed and validated by the CFD results in another 16 orthogonal experiments. Furthermore, the formula is improved for various values of Brinell hardness of carbon steel and sharpness factors of particles.

Study on Leakage Reasons of Gate Valve in Ammonium Phosphate Solution

Failure Analysis of Stainless Steel Gate Valve in Ammonium Phosphate Solution

Failure Analysis of Ball Valve Made of Stainless Steel in Ammonium Phosphate Solution

Failure Analysis on Wear of Stopcock in Alkali Solution

Fracture failure analysis on Alloy783 bolts in medium-pressure valve bonnets of USC units

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Failure analysis on synergistic effect of erosion and corrosion on failed fittings in specialty chemical plant. Part II: Control valve

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

Current status and trend of disposal techniques for ammonia leakage

Study on corrosion behavior of 13Cr gate valve using weld deposited gate and seat in well operation environments

Failure Analysis on Abnormal Leakage of Shell and Tube Heat Exchanger in Specialty Chemical Plant

Three-dimensional numerical investigation of solid particle erosion in gate valves

Understanding of ammonium salts under-deposit corrosion: Electrochemical and AIMD investigations

Failure Analysis on Abnormal Leakage of TP321 Stainless Steel Pipe of Medium Temperature Shifting Gas in Hydrogen Production System

The Models and the Reasons of Petrochemical Engineering Enterprise Safety Valve Lapse

Reason Analysis and Countermeasures for Leakage of Middle-pressure Waste Heat Boiler

Study on Liquid Ammonia Storage Vessel Release and Diffusion Models Improvement

Numerical investigation and rapid prediction of the erosion rate of gate valve in gas-solid flow

Study on Dew Point Corrosion and Ammonium Salt Depositing at Low Temperature System of Atmospheric and Vacuum Distillation Unit

Analysis of Causes and Protective Measures against Corrosion Perforation in the Shell-Side Outlet Flange of a Sour Water Steam Heater

The Analysis and Experimental Research on Sealability of the Valve Components