Abstract:As a key factor affecting thermal behaviors of liquid hydrogen (LH2) tanks, heat leakage plays an important role in accurate prediction of pressure build-up for safe storage and transportation of LH2. Uniform heat flux between vapor and liquid in LH2 tanks is widely adopted as thermal boundary condition in predicting pressure build-up process. However, a distribution of heat flux between vapor and liquid was observed during the self -pressurization process in the experimental test. In light of this, an analytically theoret-ical model of revealing the energy exchange process among the vapor, liquid and inner wall is proposed to investigate the heat leakage distribution ratio (HDR) between vapor and liquid in LH2 tanks. The feasibility of the model is validated by the experimental results from NASA. In the whole self-pressurization process of 25,000 s, HDR reduces from 0.803 to 0.235 under a liquid fill ratio of 90% and a total heat leakage of 71.3 W. The results show that the existence of inner wall and different thermal properties between the vapor and liquid make the heat leakage flux non-uniformly distributed into the vapor and liquid. And the geometric structure of tank, thermal properties and initial states of the vapor and liquid have a significant effect on HDR. When coupling the model with thermal multi-zone model, the relative error in pressure prediction is reduced by 61.8% against experimental results. Benefiting from the coupled model, the relative error in pressure prediction caused by the uniform heat flux boundary condition reduces from 90.16% to 8.15%. The present work establishes theoretical foundation on analyzing heat leakage distribution between the vapor and liquid for LH2 tanks, and provides useful guidance on modifying boundary conditions in accurately predicting thermal behaviors of LH2 tanks.(c) 2023 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Study on Liquid Ammonia Storage Vessel Release and Diffusion Models Improvement

Numerical Study of Hydrogen Leakage and Explosion in Hydrogen Refueling Station with Large Volume Hydrogen Storage Vessels

Study on Accident Model of Liquid Ammonia Storage Tank Leakage Based on Mass Flow Rate Discretization

Numerical Simulation on the Leakage and Diffusion of Hydrogen in Indoor Environment

Dynamic Response Characteristics and Damage Modes of Multifunctional Layered Hydrogen Storage Vessels under Impact Loads

Potential Hazard Analysis on Liquefied Ammonia Tank Release Based on Mathematics Simulation Calculation

Simulation analysis on release and dispersion process of liquefied ammonia tank

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Release Behaviour of a High-Pressure Vapor Vessel with Condensation: Test and Modeling Study

Micromechanics-based Burst Failure Analysis of Composite Vessel Used for Hydrogen Storage

Numerical Simulation on the Diffusion of Hydrogen Due to High Pressured Storage Tanks Failure

Numerical Investigation on Explosion of Quick Actuating Pressure Vessels Due to Residual Pressure

Theoretical investigation on heat leakage distribution between vapor and liquid in liquid hydrogen tanks

Numerical and experimental study of the explosions caused by residual pressure in quick actuating vessels

Dynamic evolution of leakage and explosion accident in high pressure hydrogen storage system

Risk Evaluation of Ammonia Leakage based on Modified Probability Calculation Formulas

Numerical Simulation of Leakage and Diffusion Process of LNG Storage Tanks

A simulation research on thermal-pressure coupling loading of a 1:3.2 containment model

Improvement and Validation of Aerosol Models for Natural Deposition Mechanism in Reactor Containment

Risk assessment of liquid ammonia tanks based on Bayesian network and Probit model

Numerical Simulation and Safety Assessment Analysis for Pressure Pipe with Incomplete Penetration Defects