Abstract:Microstructural development and nanoscale compositional variations in mechanically alloyed Fe2O3-SnO2 powders have been examined by transmission electron microscopy and energy dispersive X-ray spectrometry. The mean grain size was found to stabilize around 10 nm after 19 h milling time, in close agreement with that estimated from X-ray diffraction line broadening measurements, whereas dissolution of SnO2 grains was incomplete even after 110 h. Isolated grains with the SnO2 cassiterite structure, of diameter >10 nm, persisted up to the maximum milling time. These observations are discussed in relation to previous measurements in the same system by X-ray diffraction and Mossbauer spectroscopy, which suggested that alloying on the atomic scale occurred after 110 h milling. The present studies confirm that the amount of Sn dissolved in the Fe2O3 hematite lattice increases with longer milling times, indicating that a supersaturated solid solution is formed, but that mixing may be locally inhomogeneous at the atomic level. Similar conclusions have been reported for studies of mechanical alloying in immiscible metallic systems. The, tendency for SnO2 grains above a certain critical size to remain undissolved, while smaller grains can more easily enter into solid solution with Fe2O3, is consistent with the expected behaviour due to the increased chemical contribution to the interfacial energy with decreasing grain size. Mossbauer results also showed that some of the SnO2 had not reacted with Fe2O3 after 110 h milling.

Interstitial Positions Of Tin Ions In Alpha-(Ferichsn)(2)O-3 Solid Solutions Prepared By Mechanical Alloying

Interstitial Positions of Tin Ions in Α-(Ferichsn)2

Microstructure and gas sensitive properties of α(M: Sn and Ti) materials prepared by ball milling

An Investigation of the Local Environments of Tin in Tin-Doped Α-Fe2o3

Characterization of Nanostructured Alpha-Fe2o3-Sno2 Solid Solutions Prepared by High Energy Ball Milling

Phase Structure Analysis of AgCd and AgSn Alloy Powders

Gas-sensitive Properties and Structure of Nanostructured ( - Materials Prepared by Mechanical Alloying

Crystallographic ordering of Al and Sn in α-Ti

Transmission Electron Microscopy Studies of Mechanical Alloying in the Immiscible Fe2o3-Sno2 System

Accommodation of Tin in Tetragonal ZrO2

Changes of structure and microhardness during the annealing of an aluminium-tin supersaturated solid solution

The Magnetic Hyperfine Field in Tin-Doped Fe3o4: Variations During Oxidation and Subsequent Phase Transformations

Microstructures of Mechanically Alloyed Fe60Ni40 Studied by XAFS and XRD

Tuning of structural phase, magnetic spin order and electrical conductivity in mechanical alloyed material of alpha-Fe2O3 and alpha-Cr2O3 oxides

Structure And Magnetic Properties Of Nanocrystalline Fe73.5cu1nb3-Xtixsi13.5b9 (X=0, 1, 2, 3) Powders

Nanocrystalline Oxides and Sulphides Prepared by Hydrothermal Processing and Mechanical Milling

Atom Location by Channeling-Enhanced Microanalysis (ALCHEMI) Study of Structure of Complex Concentrated Alloys Derived From FeAl Iron Aluminide

Solid-State Alloying in Binary Systems with a Positive Heat of Mixing

Effect of the Fe/Mn Ratio on the Microstructural Evolution of the AA6063 Alloy with Homogenization Heat Treatment Interruption

Phase equilibrium diagram of the Hf-Fe-Sn system at 1070 K

Electronic structure and magnetic properties of Ni0.2Cd0.3Fe2.5-xAlxO4 (x = 0.0 - 0.4) ferrite nanoparticles