Abstract:Investment and suction casting represents a more cost effective route to produce automotive exhaust valves of gamma-TiAl based alloys, but the castings have severe gas porosities in the preliminary suction casting. It has been conferred that the generation of the porosity defects in the castings is a result directly associated with the entrapped air during filling flow. In order to investigate the filling patterns and the entrapped air during the suction casting process of automotive exhaust valves of gamma-TiAl based alloys, water modeling experiments have been done. The effect of three types of filling pressure control methods and two types of moulds on the filling patterns are systematically investigated in this paper. Results show that serious entrapped air occur during the filling flow with an rough pressure control method by means of the vents at the top of the moulds (called a general suction casting); Tranquil filling patterns are obtained under an accurate pressure control method ("gas charging" or "air leakage"), and if the gas charging flow is smaller than 1.7 m(3)/h or the air leakage flow is smaller than 1.5 m(3)/h, the entrapped air phenomenon disappear. Meanwhile, the general and the "air leakage" suction casting of TiAl automotive exhaust valves are implemented using the conclusions of the corresponding water modeling experiments, and the real casting results claim good qualitative agreement with that of the water modeling experiments. Finally, The reasonable explanation for the aforementioned results of the water modeling experiments is given using the filling kinetic principle of suction casting.

Comparison Experiments on Evacuating Capability of a High Vacuum Valve and a Zig-Zag Valve in Vacuum Die Casting Process

Calculation and Experiment on Cavity Vacuum Pressure in Vacuum Die Casting Process

Optimal Design and Test of High-speed Electro-pneumatic Ejector Valve

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Study on vacuum die casting process of aluminum alloys

Application of Vacuum and Partial Pressurization in Die Casting Automobile Components

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

The Flow and Cavitation Characteristics of Cage-Type Control Valves

Numerical Investigation Of Methodologies For Cavitation Suppression Inside Globe Valves

A feasibility study of the partial squeeze and vacuum die casting process

Effect of Vacuum on Porosity and Mechanical Properties of High-Pressure Die-Cast Pure Copper

WATER MODELING OF MOULD FILLING DURING SUCTION CASTING PROCESS OF AUTOMOTIVE EXHAUST VALVES OF Γ-Tial BASED ALLOYS

Casting of a Steel Valve Body Using Lost Foam Sand casting: Comparison Between Experimental and Simulation Results

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Effect of Vacuum Degree in Magnesium Alloy Vacuum Die Casting on Gas Porosity Ratio Based on Numerical Simulation

Modeling of filling and solidification process for TiAl exhaust valves during suction casting

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Study on Casting Defect Control of Austenitic 304 Complex Structural Parts

Simulation and Casting Process of Aluminum Alloy Multi-Way Valve Body with Various Gating Systems