Abstract:In this paper, Mg–Al–Mn (AM) series alloys were studied to develop high strength and toughness die-cast magnesium alloys by micro-multi-alloying method. AM50-X (Al, Nd, Ca) alloy samples were prepared by vacuum die casting using Al, Ca, Nd elements with obvious alloying effect. The microstructures and mechanical properties of AM50, AM70 and AM70–0.5Nd–0.5Ca alloys after die casting and heat treatment were investigated by means of microstructure observation and mechanical properties test. The results showed that the tensile strength of the die-cast AM70 alloy was higher than that of the die-cast AM50 alloy, but the elongation was lower. The AM70–0.5Nd–0.5Ca alloy showed a further increase in tensile strength and a slight decrease in plasticity. The addition of small amounts of Nd and Ca led to a refinement of the microstructure, and the elements Nd and Ca did not form new phases and dissolve mainly in the Mg 17 Al 12 phase. T4 heat treatment slightly reduced alloy hardness, while T6 heat treatment could increase alloy hardness. AM70–0.5Nd–0.5Ca alloy had the optimal overall mechanical properties after T4 treatment. The ultimate tensile strength, yield strength, elongation and hardness of AM70–0.5Nd–0.5Ca alloy reached 243.6 MPa, 145.2 MPa, 6.7% and 60.9 HBS, espectively. The improvement in the mechanical properties of AM70–0.5Nd–0.5Ca–T4 alloy could be attributed to comprehensive effect of fine grain strengthening, solid solution strengthening and dispersion strengthening caused by the improvement of Mg 17 Al 12 (Ca, Nd) phase.

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Study on vacuum die casting process of aluminum alloys

Effects of Vacuum Die Casting Process Parameters on Ultimate Tensile Strength of AZ91D Magnesium Alloy

Relationship Between Porosity Distribution and Mechanical Properties of Vacuum Die Casting AM50 Magnesium Alloy

Microstructure and mechanical properties of AM50 alloy according to thickness and forming condition of the products by a high pressure die-casting process

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

Vacuum Assisted High-Pressure Die Casting of AZ91D Magnesium Alloy at Different Slow Shot Speeds

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Low-pressure die casting of magnesium alloy AM50: Response to process parameters

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Effect of Different Casting Techniques on the Microstructure and Mechanical Properties of AE44-2 Magnesium Alloy

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Effects of Process Parameters on Morphology and Distribution of Externally Solidified Crystals in Microstructure of Magnesium Alloy Die Castings

Effect of Vacuum on Porosity and Mechanical Properties of High-Pressure Die-Cast Pure Copper

Experimental study of squeeze casting of ZK60 magnesium alloy

Effect of Alloying with Al, Nd and Ca and Heat Treatment on Microstructures and Mechanical Properties of Vacuum Die-Cast AM50 Alloy

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Study on Die Casting Technology and Casting Soundness of AM50 Magnesium Alloy