Abstract:AE44-2 magnesium (Mg) alloys were fabricated by gravity casting (GC), high pressure die casting (HPDC), and high vacuum assisted high pressure die casting (HVHPDC). The effect of these three different casting techniques on the microstructure evolution, texture, and mechanical properties of the AE44-2 alloy was investigated. The results showed that the different cooling rates in these three different casting techniques led to the different distribution and morphology of the precipitated phases, and rapid cooling contributed to a dense network distribution of the phases as well as grain refinement. In addition, the faster cooling rate resulted in a decrease of the dislocation accumulation. The addition of vacuum assistance in the HPDC process increased texture strength. The average grain size of the HPDC alloy was reduced by 90.4% compared to the GC alloy and the yield strength increased by 85.7 MPa due to rapid cooling. The elongation of the HVHPDC alloy increased by 2.3% compared to the HPDC alloy due to vacuum assistance. Moreover, the mechanical properties improved for the alloys in the order of GC < HPDC < HVHPDC because of gran refinement caused by the faster cooling rate. Based on the analysis of the strengthening mechanisms, the rapid cooling process of the HPDC alloy led to better strengthening compared to the GC alloy. In addition, grain refinement contributed to 82.1% of the strengthening mechanism.

Vacuum Assisted High-Pressure Die Casting of AZ91D Magnesium Alloy at Different Slow Shot Speeds

Effect of Multi-Step Slow Shot Speed on Microstructure of Vacuum Die Cast AZ91D Magnesium Alloy

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Characterization of A390 Aluminum Alloy Produced at Different Slow Shot Speeds Using Vacuum Assisted High Pressure Die Casting

Correlation Between Density and Microstructural Features in Vacuum Die Cast AZ91D Magnesium Alloy

Improved mechanical properties in vacuum-assist high-pressure die casting of AZ91D alloy

The Effect of Slow Shot Speed and Casting Pressure on the 3D Microstructure of High Pressure Die Casting AE44 Magnesium Alloy

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Effects of Vacuum Die Casting Process Parameters on Ultimate Tensile Strength of AZ91D Magnesium Alloy

Fast shot speed induced microstructure and mechanical property evolution of high pressure die casting Mg-Al-Zn-RE alloys

Influence of Melt Flow in the Gating System on Microstructure and Mechanical Properties of High Pressure Die Casting AZ91D Magnesium Alloy

The effect of different high pressure die casting parameters on 3D microstructure and mechanical properties of AE44 magnesium alloy

Correlation of 3D Defect-Band Morphologies and Mechanical Properties in High Pressure Die Casting Magnesium Alloy

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

Effect of Slow Shot Speed on Externally Solidified Crystal, Porosity and Tensile Property in a Newly Developed High-Pressure Die-Cast Al-Si Alloy

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Effects of Casting Pressure on Microstructure and Mechanical Properties of Super Slow Speed Die Castings of ADC12 Aluminum Alloy

Effects Of Slow, Shot Speed Of Sss Die Casting On Microstructure And Mechanical Properties Of Aluminum Alloys Adc12

Effect of Different Casting Techniques on the Microstructure and Mechanical Properties of AE44-2 Magnesium Alloy

Analysis of Fractures and Microstructures on Different Injection Speeds in High-Pressure Die-Casting Magnesium Alloy