Abstract:Aluminium is one of the basic materials used in many sectors, especially in automotive, defence and aviation. Generally, aluminium parts are manufactured by using injection molding methods in many sectors, such as automotive, etc. Injection presses that are used for die-casting material have a lot of parameters, affect the molded parts’ properties. In this study, the effect of injection parameters on the mechanical properties was investigated. Firstly, a test part that is shaped currently on the injection press machine in a sector was found out. An aluminum alloy, named Al〖Si〗_12 Cu (EN AC 47000), that is used widely in die-casting techniques was preferred. Three injection parameters, such as, injection velocity (m/s), time of the mold opening (s) and molten metal temperature (0C), were selected. And all works were planned with the full factorial experimental design method. Thus, the test parts were manufactured by using an injection molding machine. Moreover, many tests, such as hardness and tensile, were performed on the test parts to investigate the effect of injection parameters on the mechanical properties of the material. The tests were analysed with the full factorial and ANOVA method. As a results of the analysis, the highest hardness value was obtained as 85 HB when the molten metal temperature was 750 °C, the injection velocity was 1.3 m/s, the mold opening time was 10 s, and the highest breaking strength was obtained as molten metal temperature 725 °C, injection velocity 4 m/s, when the mold opening time was 12 s was found to be 264 MPa.

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Influence of Die Casting Parameters and Core on Mold-Filling Capacity of AZ91D Magnesium Alloy

Effects of processing parameters on grain size in die casting magnesium alloy AZ91HP castings

Effects of Vacuum Die Casting Process Parameters on Ultimate Tensile Strength of AZ91D Magnesium Alloy

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Research of Die-Casting Process of ZA85 Magnesium Alloys

Research on the Comparison of the Macroscopic Defect and the Mechanical Property of AZ91D Magnesium Alloy Parts Produced by Liquid Combination Process of Die Casting and Forging and Liquid Die Casting

Influences of Casting Pressure Conditions on the Quality and Properties of a Magnesium Cylinder Head Cover Die Casting

Experimental study of squeeze casting of ZK60 magnesium alloy

Study on Interfacial Heat Transfer Coefficient at Metal/die Interface During High Pressure Die Casting Process of AZ91D Alloy

Influence of the Velocity and Start Position of High-Speed Injection Stage on the Quality of Magnesium Alloy Die Casting

Low-pressure die casting of magnesium alloy AM50: Response to process parameters

Forming Technique of Magnesium Alloy Parts Produced by Liquid Combination Process of Die Casting and Forging

The Effect of Aluminium Injection Parameters on the Mechanical Properties of the Material Produced by High Pressure Die-Casting

Study on Pressurized Solidification Behavior and Microstructure Characteristics of Squeeze Casting Magnesium Alloy AZ91D

On the Deformation Behavior of Heterogeneous Microstructure and Its Effect on the Mechanical Properties of Die Cast AZ91D Magnesium Alloy

Vacuum Assisted High-Pressure Die Casting of AZ91D Magnesium Alloy at Different Slow Shot Speeds