Abstract:The semi-solid high-pressure die casting is playing an increasingly important role in the field of automotive lightweight. Herein, a numerical simulation study on the semi-solid die casting process of 319s aluminum alloy test bars was carried out. By setting different die casting process parameters for simulation calculation, the defect location, distribution, and content were analyzed in this paper. The best die casting process parameters were determined, which were with injection rate of 1 m/s and die casting temperature of 570 °C. According to the simulated defect location, the overflow system of the test bar was optimized, including the design of the overflow groove, sprue and venting channel. The semi-solid slurry was prepared by the Swirled Enthalpy Equilibration Device. Trial production of the test bar was carried out with the best die casting process parameters. The casting product is well filled and has no obvious defects. The experimental results show that the microstructure of test bar has fine and rounded grains with an average size of 28.27 μm and an average shape factor of 0.86. After T6 heat treatment, the transformation of the morphology and distribution of the strengthening phases plays a crucial role in the improvement of mechanical properties. The tensile strength increases from 269 MPa of 319s-F to 395 MPa of 319s-T6, but the elongation decreased slightly from 7.3 to 6.2 %.

Study on Die Casting Technology and Casting Soundness of AM50 Magnesium Alloy

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Influence of Processing Parameters on Microstructure and Mechanical Properties of Die Casting AM50 Alloy

Low-pressure die casting of magnesium alloy AM50: Response to process parameters

Research on the Influence of Die Casting Process on Structure and Performance of Magnesium Alloy

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Relationship Between Porosity Distribution and Mechanical Properties of Vacuum Die Casting AM50 Magnesium Alloy

Numerical simulation of die casting process of magnesium alloy

Experimental study of squeeze casting of ZK60 magnesium alloy

Effect of Solutionising and Ageing on the Microstructure and Mechanical Properties of a High Strength Die-Cast Al–Mg–Zn–Si Alloy

Microstructure and mechanical properties of AM50 alloy according to thickness and forming condition of the products by a high pressure die-casting process

Research of Die-Casting Process of ZA85 Magnesium Alloys

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Research On Alloying Tecniques Of Mischmetal In Die Casting Magnesium Alloy

Microstructure and mechanical properties of low pressure die cast AM50 magnesium alloy

Study on Process of Magnesium Alloy Investment Casting

Research on the Improvement of Soundness AG 40 A Zinc Alloy Casting

Research Progress of Casting Process for High Performance Magnesium Alloys

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Simulation on Die Casting Process for Magnesium Alloy Steering Wheel Frame

Numerical Simulation and Experimental Study on Semi-solid Forming Process of 319s Aluminum Alloy Test Bar