Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Study on Pressure Variations in the Mold of Magnesium Alloy Die Castings

Influences of Casting Pressure Conditions on the Quality and Properties of a Magnesium Cylinder Head Cover Die Casting

Comparative Study of the Cavity Pressure of Magnesium Alloy and Aluminium Alloy During Die Casting Process

Influence of the Velocity and Start Position of High-Speed Injection Stage on the Quality of Magnesium Alloy Die Casting

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Experimental study of squeeze casting of ZK60 magnesium alloy

Quality Control Study on High Pressure Casting Based on Magma and Ultra-red Simulation

Study on Pressurized Solidification Behavior and Microstructure Characteristics of Squeeze Casting Magnesium Alloy AZ91D

The Effect of Slow Shot Speed and Casting Pressure on the 3D Microstructure of High Pressure Die Casting AE44 Magnesium Alloy

Research of Die-Casting Process of ZA85 Magnesium Alloys

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

High Pressure Die Casting Process of Magnesium Alloys and Its Modeling and Simulation for Automobile Industry

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Microstructure and mechanical properties of AM50 alloy according to thickness and forming condition of the products by a high pressure die-casting process

Characteristics of Mold Filling and Entrainment of Oxide Film in Low Pressure Casting of A356 Alloy

The effect of different high pressure die casting parameters on 3D microstructure and mechanical properties of AE44 magnesium alloy

Research on the Influence of Die Casting Process on Structure and Performance of Magnesium Alloy

Low-pressure die casting of magnesium alloy AM50: Response to process parameters