Abstract:AE44-2 magnesium (Mg) alloys were fabricated by gravity casting (GC), high pressure die casting (HPDC), and high vacuum assisted high pressure die casting (HVHPDC). The effect of these three different casting techniques on the microstructure evolution, texture, and mechanical properties of the AE44-2 alloy was investigated. The results showed that the different cooling rates in these three different casting techniques led to the different distribution and morphology of the precipitated phases, and rapid cooling contributed to a dense network distribution of the phases as well as grain refinement. In addition, the faster cooling rate resulted in a decrease of the dislocation accumulation. The addition of vacuum assistance in the HPDC process increased texture strength. The average grain size of the HPDC alloy was reduced by 90.4% compared to the GC alloy and the yield strength increased by 85.7 MPa due to rapid cooling. The elongation of the HVHPDC alloy increased by 2.3% compared to the HPDC alloy due to vacuum assistance. Moreover, the mechanical properties improved for the alloys in the order of GC < HPDC < HVHPDC because of gran refinement caused by the faster cooling rate. Based on the analysis of the strengthening mechanisms, the rapid cooling process of the HPDC alloy led to better strengthening compared to the GC alloy. In addition, grain refinement contributed to 82.1% of the strengthening mechanism.

Comparative Study of the Cavity Pressure of Magnesium Alloy and Aluminium Alloy During Die Casting Process

Study on Pressure Variations in the Mold of Magnesium Alloy Die Castings

Study on Pressurized Solidification Behavior and Microstructure Characteristics of Squeeze Casting Magnesium Alloy AZ91D

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Study on Interfacial Heat Transfer Coefficient at Metal/die Interface During High Pressure Die Casting Process of AZ91D Alloy

Research on the Comparison of the Macroscopic Defect and the Mechanical Property of AZ91D Magnesium Alloy Parts Produced by Liquid Combination Process of Die Casting and Forging and Liquid Die Casting

Effect of Casting Pressure on Porosity and Mechanical Properties of ADC12Z Die Castings

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Influence of Melt Flow in the Gating System on Microstructure and Mechanical Properties of High Pressure Die Casting AZ91D Magnesium Alloy

Study on vacuum die casting process of aluminum alloys

Effects of Alloy Materials and Process Parameters on the Heat Transfer Coefficient at Metal/Die Interface in High Pressure Die Casting

Effect of Different Casting Techniques on the Microstructure and Mechanical Properties of AE44-2 Magnesium Alloy

Effects of Casting Pressure on Microstructure and Mechanical Properties of Super Slow Speed Die Castings of ADC12 Aluminum Alloy

Low-pressure die casting of magnesium alloy AM50: Response to process parameters

Vacuum Assisted High-Pressure Die Casting of AZ91D Magnesium Alloy at Different Slow Shot Speeds

Influence of Die Casting Parameters and Core on Mold-Filling Capacity of AZ91D Magnesium Alloy

On the Deformation Behavior of Heterogeneous Microstructure and Its Effect on the Mechanical Properties of Die Cast AZ91D Magnesium Alloy

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy