Abstract:Due to moisture in the ore, auxiliary material, and ladle refractory material, the hydrogen element is easily enriched in molten steel. In the metallurgy process, some hydrogen atoms form bubbles and are removed by gravity, whearas others solidify in the strand and remain in the produced steel. When the hydrogen content reaches a certain critical value, the enriched hydrogen atoms congregate to produce a white spot, which greatly reduces the strength and toughness of the steel product, and leads to brittle fracture during its service period. At present, the RH (Ruhrstahl–Heraeus) and VD (vacuum degasser) refining processes are commonly applied in steel plants, which can reduce the hydrogen content to less than 2×10−6. With the demand for high quality steel, the hydrogen content must be further decreased, so hydrogen diffusion in solid steel during the annealing process is gradually attracting increasing attention. In this study, a two-dimensional model was built to investigate the characteristic of dehydrogenation in the bloom annealing process of rail steel. Moreover, the effect of annealing temperature and annealing time on hydrogen diffusion were analyzed, and the annealing parameters were optimized. During the dehydrogenation annealing process, the hydrogen content at the corners and edges of the bloom are found to decrease rapidly, while that in the center of the strand begin to decrease in the later heating stage. As the annealing temperature increases, the starting point of dehydrogenation in the bloom center moves ahead and the maximum dehydrogenation rate increases significantly. With the extension of the soaking period, the central hydrogen content of bloom decreases significantly, but the increase rate of the dehydrogenation gradually decreases. By optimizing the bloom annealing parameters, the hydrogen content in the bloom can be steadily reduced to 0.6×10−6, which fully meets the requirement of high quality steel production.

Industrial Experiment of Technique Optimization on IF Steel in RH Degasser

Numerical Simulation of Dehydrogenation Annealing in Bloom

Impact on the Instability of Carbon Content of IF Steel

Optimizing RH refining process to maximize cleanliness of low-carbon low-silicon Al killed steel

New steelmaking process based on clean deoxidation technology

Control of oxide inclusion for low carbon and low silicon steel

Mathematical Simulation of Decarburization with CO2 Injection During RH Refining of Ultra-Low-Carbon Steel

Development and prospects of molten steel deoxidation in steelmaking process

Process Improvement of Developing Cold-Rolled ULC Steel on RH

Dephosphorization of high silicon hot metal based on double slag converter steelmaking technology

Carbon Control in IF Steel Producing Process in PZH Steel

Revolution and Control of Fe-Al-(Mg, Ti)-O Oxide Inclusions in IF Steel during 260t BOF-RH-CC Process

Study on oxygen blowing optimisation of reducing (FeO) content in slag in EAF steelmaking process with high ratio of hot metal to scrap

STUDY ON THE RECOVERY OF HIGH PURITY IRON OXIDE FROM PICKLING WASTE LIQUOR OF STEEL SHEET

Investigation into Recycling of Iron Oxide Scale on H13 Steel by Low‐Temperature Carbothermal Reduction Method

Physical Simulation Study on Flow Field Characteristics of Molten Steel in 70t Ladle Bottom Argon Blowing Process

Application of heat absorption method to reduce macrosegregation during solidification of bearing steel ingot

Effect of Al-Ti complex deoxidation mode on steel cleanliness during RH refining of IF steels

Simulation research on oxygen mass transfer between steel and slag in IF steel refining process

Research of slagless steelmaking and technology control in converter

Behavior of Carbothermal Dephosphorization of Phosphorus-Containing Converter Slag and Its Resource Utilization