Abstract:YSZ buffer layers and YBCO superconducting layers were grown on biaxially textured NiW tapes by a reel-to-reel pulsed laser deposition (PLD) technique. It was found that orientation and surface morphology of YSZ buffer layers were very sensitive to deposition parameters, especially to oxygen pressure and laser repetition rate. Relationships between microstructure, surface morphology of YSZ buffer layer and PLD deposition parameters were systematically studied using X-ray diffraction (XRD) and scanning electron microscopy (SEM). The effects of surface morphology of YSZ buffer layer on the superconducting performance of YBCO layer were investigated. As increasing oxygen pressure from 0.5 to 10 mTorr, the surface morphology of YSZ buffer layer became better first and then worse, however, it deteriorated with the increase of laser repetition rate. It was found that the surface morphology of YSZ buffer layer had great influence on the superconducting transport properties of YBCO layer. Under optimized experimental condition, high quality YBCO layer with critical current density Jc above 4 × 106 A/cm2 was obtained at 77 K and self field.

Factors Affecting Power Handling Capability of Microstrip Resonator

Frequency-Dependent Maximum Average Power-Handling Capabilities of Single and Edge-Coupled Microstrip Lines on Low-Temperature Co-Fired Ceramic (ltcc) Substrates

Characterization of Average Power Handling Capability of Bandpass Filters Using Planar Half-Wavelength Microstrip Resonators

Wide-band characterization of average power handling capabilities of some microstrip interconnects on polyimide and polyimide/GaAs substrates

Wideband Average Power Handling Capability of Coupled Microstrips on Polyimide and Polyimide∕gaas Substrates

The Interpretation of the Power Dependence of the Unloaded Quality Factor of Superconductive Microstrip Resonators

Power Dependence of Radiation Efficiency of Circularly Polarized Yba2cu3o7 Microstrip Antennas

Dispersion characteristics of V-shaped microstrip lines

Finite-Ground Thin-Film Microstrip Interconnects (tfmis) and Their Power Handling Capabilities over Ultra-Wide Frequency Ranges

The Edge Effect of a Microstrip Resonator on the Field Dependence of the Surface Resistance of a High- T c Superconducting Thin Film

Temperature and Power Characteristics of Quarter-Wavelength Superconducting Coplanar Waveguide Resonator

Average Power Handling Capability of Microstrip Lines Considering Heat Convection and Self-Heating Effects With Temperature-Dependent Resistivity

Influence of α- and β-W phases on performance of SMR devices

Improvement of Surface Morphology of Yttrium-Stabilized Zirconia Films Deposited by Pulsed Laser Deposition on Rolling Assisted Biaxially Textured Substrate Tapes

A Power Handling Capability Improved HTS Filter Using Modified Sliced Line Resonators

How the Surface Resistance R s of Patterned High- T c Superconducting Thin Film Is Affected by the Film's Edge

Effects of YSZ Buffer Layer Surface Morphology on Superconducting Performance of YBCO Films Deposited by Pulsed Laser Deposition on NiW Tapes

A novel method to improve the power capabilities of microwave components

EFFECTS OF PHYSICAL CHARACTERISTICS ON YBCO HTS THIN FILM BY ARGON ION BEAM ETCHING

Thickness-dependent Magnetic and Microwave Resonance Characterization of Combined Stripe Patterned FeCoBSi Films