Abstract:Tank circuit (resonator) is essential for the operation of the radio frequency (rf) superconducting quantum interference device (SQUID) and the quality factor of the tank circuit has significant impact on the sensitivity of the rf SQUID. For high transition temperature (high-Tc) rf SQUID, dielectric resonator is presently one of the most practical tank circuits. By growing YBa2Cu3O7−δ (YBCO) superconducting thin film on (100) SrTiO3 substrate with a pulsed-laser deposition technique and then patterning the YBCO thin film into flux concentrator with a washer structure, a series of dielectric resonators with unloaded quality factor Q0 ranging from 200 to 6000 has been prepared. Surface morphology and electrical transport measurements have been carried out to investigate the dependence of Q0 on the property of the YBCO thin film, which suggests that it is effective to boost the Q0 of the resonator through improvements in both the crystalline quality and the superconductivity of the thin film. By integrating the resonators with the same SQUID chip, a set of YBCO rf SQUIDs has been assembled to explore the influence of Q0 of the resonator on the performance of the rf SQUID. It is observed that the white noise of the device decreases substantially with the increase of Q0, in accordance with the theoretical suggestion. Moreover, as Q0 rises, the low frequency noise of the device is shown to reduce as well, revealing the importance of the high-Q0 resonator in depressing the noise of the high-Tc rf SQUID over the entire frequency range. With the resonator of Q0=6000, the YBCO rf SQUID at 77 K exhibits a field sensitivity of 50 fT/Hz1/2 in the white noise region, 58 fT/Hz1/2 and 110 fT/Hz1/2 at 10 Hz and 1 Hz respectively, suggesting its potential in applications such as magnetoencephalography in biomagnetism which have critical requirements on field sensitivity of the high-Tc SQUID especially at low frequencies.

Temperature and Power Characteristics of Quarter-Wavelength Superconducting Coplanar Waveguide Resonator

Power and temperature dependent model for High Q superconductors

Experimental Demonstrations of High-Q Superconducting Coplanar Waveguide Resonators

Temperature Characteristic of Ring Resonator in Polarization Maintaining Silica Optical Waveguide

Interplay of coupling, residual, and quasiparticle losses for the frequency- and temperature-dependent quality factor of superconducting resonators

Loss Dependence on Geometry and Applied Power in Superconducting Coplanar Resonators

Geometry Characteristics and Wide Temperature Behavior of Silicon-Based GaN Surface Acoustic Wave Resonators with Ultrahigh Quality Factor

High-Q trenched aluminum coplanar resonators with an ultrasonic edge microcutting for superconducting quantum devices

Substrate surface engineering for high-quality silicon/aluminum superconducting resonators

Temperature, RF Field, and Frequency Dependence Performance Evaluation of Superconducting Niobium Half-Wave Cavity

Electromagnetic Design and Optimization of a Superconducting Quarter Wave Resonator

High Quality Factor Superconducting Coplanar Waveguide Fabricated with Tin

Single and Double Superconducting Coplanar Waveguide Resonators

Phononic loss in superconducting resonators on piezoelectric substrates

Investigating Millimeter-Wave Thin-film Superconducting Resonators: A Study Using Tunnel Junction Detectors

Effects of Heat Leakage and Internal Irreversibility on Quality Factor of Thermoacoustic System

Planar superconducting resonators with internal quality factors above one million

Preparation of high-quality factor dielectric resonators for low-noise YBa2Cu3O7−δ radio frequency superconducting quantum interference devices

Crosstalk Between Nb Superconducting Coplanar Waveguide Resonators

The power-dependent test of high temperature superconductor CPW transmission line