Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Control Methods of Low Frequency Combustion Instabilities in a Dump Combustor

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Optimal Control of Turbulent Premixed Combustion Instability with Annular Micropore Air Jets

A Bayesian Optimization Framework for the Control of Combustion Instability of a Bluff-Body Stabilized Combustor

Transfer Function Calculations for Aeroengine Combustion Oscillations

Dynamics Suppression in Liquid-Fueled Combustors Using Fuel Modulation

Low Frequency Beating Instability in a Rijke Burner and its Active Control

Experimental Research on Using CO2-Ar Microjets to Control Liquid Fuel Combustion Instability and Pollutant Emission

ICOPE-15-C047 Dynamics of Non-premixed Flames with Modulations in the Air Flow for a Bluff-body Burner

Combustion Instability and Emission Characteristics of Spray Flame under Flue Gas Jet

Instability Behaviors and Suppression of the Unsteady Autoignited Turbulent Jet Flame in Hot Coflow

Controlling Thermoacoustic Instability in a Swirl Combustor Based on a Transverse Jet

Feedback control of combustion oscillations in combustion chambers

Flame dynamics and oscillation characteristics based on statistical analysis in a combustor with prefilming and non-prefilming atomization

Active suppression of swirl-stabilized combustion instability

Experimental investigation on the effects of transverse injection distribution scheme on dual flame dynamics subjected to flow disturbances

Effects of Different Active Control Strategies on Combustion Instability Decay Time, Actuator Voltage, and Damping Ratio

The effect of inlet boundaries on combustion instability in a pressure-elevated combustor

Summarization of low-frequency oscillatory combustion study

Flame dynamics and combustion instability induced by flow-flame interactions in a centrally-staged combustor