Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental Investigation on Critical Slowing Down of Premixed Combustion in a Backward-Facing Step Combustor

Active Control of Low-Frequency Combustion Instabilities in a Dump Combustor

Experimental Study on Self-Excited Thermoacoustic Instabilities and Intermittent Switching of Azimuthal and Longitudinal Modes in an Annular Combustor

Investigation of low frequency combustion instabilities in a model ramjet combustor

Numerical Simulation of Open Active Control of Low Frequency Combustion Instability Related to Vortex Shedding in Model Ramjet Dump Combustor

Variable structure control of unstable combustion

Control Methods of Low Frequency Combustion Instabilities in a Dump Combustor

Transfer Function Calculations for Aeroengine Combustion Oscillations

A Method of Active Control Nonlinear Combustion Instability

Effects of Different Active Control Strategies on Combustion Instability Decay Time, Actuator Voltage, and Damping Ratio

Experimental Study on Self-Excited Oscillations in Premixed Combustor

Experimental Research on Low-Frequency Instability in Ramjet Combustor

Experimental Investigation on Characteristics of Thermoacoustic Oscillations in a Stagnation Point Reverse Flow Combustor

Experimental Study on Combustion Instability Characteristics of a Lean Premixed Prevaporized Combustor

Study on Combustion Instability of Secondary Combustion in an Axial Staged Model Combustor

Experimental and numerical study of nonlinear growth process of self-excited combustion instability in a model rocket combustor

Acoustic Triggering of Combustion Instability in a Swirling Flame: An Experimental Study

Active Control of Combustion Instabilities Using Model-Based Controllers

Low Frequency Beating Instability in a Rijke Burner and its Active Control