Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Feedback control of combustion oscillations in combustion chambers

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Interpretation of Intermittent Combustion Oscillations by a New Linearization Procedure

Active Control of Combustion Instabilities Using Model-Based Controllers

Active control of combustion oscillations based on Desired Dynamic Equation

Experimental Study on Self-Excited Thermoacoustic Instabilities and Intermittent Switching of Azimuthal and Longitudinal Modes in an Annular Combustor

Thermoacoustic instabilities: Modeling and control

Active control of combustion oscillation with active disturbance rejection control (ADRC) method

A Review of Active Control Approaches in Stabilizing Combustion Systems in Aerospace Industry

Analysis And Simulation Of Combustion Oscillations In A Laboratory Spray Combustor

Low Frequency Beating Instability in a Rijke Burner and its Active Control

Acoustic Control of Thermoacoustic Instabilities Using Experimental Model-Based Controllers

Combustion Rumble Prediction with Integrated Computational-Fluid-Dynamics/Low-Order-Model Methods

Sliding Mode Control for Longitudinal Oscillating Combustion

Dynamic compensation based adaptive control of thermo-acoustic instabilities in Rijke tube: an experimental validation.

Transfer Function Calculations for Aeroengine Combustion Oscillations

Robust Control of Combustion Oscillation Based on Observer

Active suppression of swirl-stabilized combustion instability

A Bayesian Optimization Framework for the Control of Combustion Instability of a Bluff-Body Stabilized Combustor

Effects of Different Active Control Strategies on Combustion Instability Decay Time, Actuator Voltage, and Damping Ratio