Abstract:Large-amplitude self-excited thermoacoustic oscillations arising due to the interaction between unsteady heat release and acoustic pressure fluctuations have been encountered in many thermal devices. These oscillations may lead to unwanted structural vibrations and efficiency reduction while emitting loud noises, and thus the predicting of such oscillations is very important. Physically, oscillation is a kind of instability, so stability analysis can be applied to understanding such a phenomenon. The present work focuses on the role of time delay between unsteady heat release and flow perturbation in the stability of thermoacoustic system. To this end, one-dimensional Rijke tube model with both open ends is numerically investigated. In the Rijke tube model, an electric heater is located at the first quarter of the Rijke tube and its unsteady heat release rate is modeled by an empirical model proposed by Heckl. Non-dimensional momentum equation and energy equation of the acoustic perturbation are derived and solved in time domain by using the Galerkin technique. The time evolution of the thermoacoustic oscillations with continuous increase in the time delay is calculated in two different acoustic damping cases, namely the heavily damped case and the weakly damped case, while other parameters are fixed. It is found that in both the heavily damped case and the weakly damped case, the system stability switches between stability and instability as the time delay increases, which is called stability switching and is a typical nonlinear phenomenon in a delay-dependent system. However, compared with in the heavily damped case, in the weakly damped case, the stability region is enlarged and the amplitude of the limit cycle oscillation is increased. Besides, in the weakly damped system, the dominating mode of system shifts in the first three modes instead of keeping in the first mode during increasing the time delay, which suggests that for the weakly damped system, the higher modes cannot be neglected and the system cannot be analyzed with a single-mode model either. Further, the bifurcation plots for the variation of the time delay for these two cases show that the system stability changes with time delay for a period of two, which is equal to the period of the first acoustic mode. As a conclusion, the results of present work indicate that the time delay between unsteady heat release and flow perturbations plays a critical role in generating thermoacoustic oscillations, and the findings of stability switching can help to understand the nonlinear phenomena in thermoacoustic systems.

Dynamic compensation based adaptive control of thermo-acoustic instabilities in Rijke tube: an experimental validation.

Investigation on nonlinear thermoacoustic effects of Rijke tube

Boundary proportional control of thermoacoustic instability in a Rijke tube

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Thermo-Acoustic Beating Oscillations in Rijke Tubes and Its Active Control

Experimental Study on Self-Excited Thermoacoustic Instabilities and Intermittent Switching of Azimuthal and Longitudinal Modes in an Annular Combustor

Numerical Modeling of Self-excited Thermoacoustic Instability in Rijke Tube

Low Frequency Beating Instability in a Rijke Burner and its Active Control

Investigation on control effects of loudspeaker on the thermoacoustic instability in a rijke combustor

Investigation of the Control Effects of the Transverse Jet on the Thermoacoustic Instability in the Rijke Combustor

Numerical and Experimental Demonstration of Actively Passive Mitigating Self-Sustained Thermoacoustic Oscillations

Acoustic Control of Thermoacoustic Instabilities Using Experimental Model-Based Controllers

Experimental Application of Predictive Cost Adaptive Control to Thermoacoustic Oscillations in a Rijke Tube

Control of Self-Excited Thermoacoustic Oscillations Using Transient Forcing, Hysteresis and Mode Switching

Thermoacoustic instabilities: Modeling and control

Feedback control of combustion oscillations in combustion chambers

Suppression of thermo-acoustic instabilities in horizontal Rijke tube using pulsating radial jets

Passive Control of Thermoacoustic Instability in a High-Efficiency Domestic Gas Stove with Fine-Tuning Burner

Stability switching behavior of thermoacoustic oscillation in Rijke tube

Investigation of the buoyancy effect on the thermoacoustic instability in an electrically heated Rijke tube

Active Control of Combustion Instabilities Using Model-Based Controllers