Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Dynamics Suppression in Liquid-Fueled Combustors Using Fuel Modulation

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Dual-fuel, dual-swirl burner for the mitigation of thermoacoustic instabilities in turbulent ammonia-hydrogen flames

Transfer Function Calculations for Aeroengine Combustion Oscillations

Optimal Control of Turbulent Premixed Combustion Instability with Annular Micropore Air Jets

Experimental Study on Combustion Stability Characteristics in Liquid-Fueled Gas Turbine Model Combustor: Fuel Sensitivities and Flame/flow Dynamics

A Bayesian Optimization Framework for the Control of Combustion Instability of a Bluff-Body Stabilized Combustor

Flame dynamics and oscillation characteristics based on statistical analysis in a combustor with prefilming and non-prefilming atomization

ICOPE-15-C047 Dynamics of Non-premixed Flames with Modulations in the Air Flow for a Bluff-body Burner

Thermoacoustic Instability Suppression and Heat-Release Forcing of a Laminar Flame Using Ionic Wind

Experimental Research on Using CO2-Ar Microjets to Control Liquid Fuel Combustion Instability and Pollutant Emission

Combustion Dynamics of Ten-injector Rocket Engine Using Flamelet Progress Variable

Control of Self-Excited Thermoacoustic Oscillations Using Transient Forcing, Hysteresis and Mode Switching

Combustion Oscillations in Burners with Fuel Spray Atomisers

Thermoacoustic Instability Characteristics and Flame/Flow Dynamics in a Multinozzle Lean Premixed Gas Turbine Model Combustor Operated with High Carbon Number Hydrocarbon Fuels

A Review of Active Control Approaches in Stabilizing Combustion Systems in Aerospace Industry

Active suppression of swirl-stabilized combustion instability

Forced Oscillations in Combustors With Spray Atomizers

Autoignition and Flame Lift-off Behavior of a Fuel Jet Mixing with Turbulent Hot Air Coflow

Mitigating Combustion Instability and NOx Emissions with Annular Oxyfuel Jets into the Flame Shear Layer Region